Specifications
– 35 –
Symptom Check for the Following Remedy
No heat during
the dry cycle.
1. Defective heater element. 1. Replace the heater element.
2. Damaged or defective wiring. 2. Repair the wiring.
Dishwasher will
not fi ll with water
or will not fi ll
properly.
.
1. The water supply is turned
off.
1. Turn the water supply on.
2. Low water pressure. 2. Minimum water pressure of
20 PSI.
3. Defective water fi ll valve. 3. Replace the water fi ll valve.
4. Obstructed water fi ll valve or
hose.
4. Disassemble and clean the
water fi ll valve and hose.
5. Damaged or defective wiring. 5. Repair the wiring.
6. Defective pressure switch. 6. Replace the pressure switch.
7. Heavy water usage
elsewhere in home.
7. Use dishwasher when water
usage is at a minimum.
Dishwasher will
not pump out.
1. Defective drain pump. 1. Replace the drain pump.
2. Defective impeller. 2. Replace the impeller.
3. Defective electronic control. 3. Replace the electronic
control.
Water siphons
out.
1. Drain hose loop too low. 1. Move the drain hose to the
proper height.
2. Drain line connected to a
fl oor drain not properly vented.
2. Install a vent air gap at
counter top.
Too much water
fi ll.
1. Defective water fi ll valve. 1. Replace the water fi ll valve.
Water leaks from
dishwasher.
1. Too much water fi ll. 1. See previous symptom.
2. Defective tub seal. 2. Replace the tub seal.
3. Defective vent plate. 3. Replace the vent plate.
4. Dishwasher door not level. 4. Adjust the dishwasher door.
5. Dishwasher not level. 5. Level the dishwasher.
6. Soap suds leak from
dishwasher.
6. Refer to use and care
manual.
7. Loose hose clamps. 7. Tighten or replace hose
clamps.
8. Loose heater element. 8. Tighten heater element
mounting nuts.
9. Defective water seals. 9. Replace the water seals.
10. Motor and pump assembly
not seated properly in tub liner
bottom.
10. Remount the motor and
pump assembly in the tub liner
bottom.
(Continued next page)