Specifications
– 36 –
Sympton Check for the Following Remedy
Poor washability. 1. Improper loading of dishes,
pots, pans, and nesting of
silverware.
1. Instruct the customer on
proper loading of the dishwasher.
Refer to the Owner's Manual.
2. Defective spray arm. 2. Check spray arm for proper
rotation.
3. Water level should cover
heating element.
3. See “Dishwasher will not
fi ll with water or will not fi ll
properly” symptom.
4. Defective detergent/rinse
module.
4. Replace the detergent/rinse
module.
5. Old, improper amount, or
wrong type of detergent used
(detergents lose effectiveness
in a damp area).
5. Instruct the customer on
proper use of dishwasher
detergent. Refer to the Owner's
Manual.
6. Low incoming water
temperature.
6. Incoming water temperature
of 120°F is required to properly
dissolve dishwashing detergents.
7. Clogged fi lter assembly. 7. Clean the fi lter assembly and
microfi lter.
Poor drying of
dishes.
1. Improper loading of dishes,
pots, pans, and nesting of
silverware.
1. Instruct the customer on
proper loading of the dishwasher.
Refer to the Owner's Manual.
2. Low incoming water
temperature.
2. Incoming water temperature
of 120°F is required to properly
dissolve dishwashing detergents.
3. Water remaining in tub after
drain cycle is completed.
3. See “Dishwasher will not pump
out” symptom.
4. Defective heating element. 4. Replace the heating element.
5. Damaged or defective
wiring.
5. Repair the wiring.
Door will not
latch.
1. Defective door latch. 1. Replace the door latch.
Noisy pump
assembly.
1. Defective motor bearings. 1. Replace the pump motor.
2. A sucking sound is heard at
the end of the cycle.
2. This is a normal condition.
Detergent left in
the dispenser.
1. Detergent allowed to stand
too long in the dispenser.
1. Instruct the customer on
proper use of dishwasher
detergent. Refer to the Owner's
Manual.
2. Dispenser was wet when
detergent was added.
2. Instruct the customer on
proper use of dishwasher
detergent. Refer to the Owner's
Manual.
3. Detergent is binding on
detergent/rinse module cover.
3. Replace the heating element.
4. Detergent cup held closed or
blocked by large dishes.
4. Instruct the customer on
proper loading of dishwasher.
Refer to the Owner's Manual.
cycle is completed.
(Continued next page)