Specifications

– 38 –
Washability Complaints
Hot Water – Ample supply of water at a
temperature of 120°F (60°C) is necessary for best
results. Do not use dishwasher soon after using
clothes washer or lling bathtub.
Loading - Consult Owner’s Manual on loading
procedures.
Amount of Water – Make sure dishwasher is
level. Check water level, allowing dishwasher to
ll normally for rst ll. The water level should be
to the heating coil. If water level is low, check for
clogged screen and check pressure switch. (See
Water Valve.)
Detergent/Rinse Module Leakage – Some moisture
in cup is normal. Detergent must not be soaking
wet, oozing out, and down the inner door panel. If a
leak is detected, check the detergent/rinse module
door lid, latch operation, and gasket seal. (See
Detergent/Rinse Module.)
Proper Amount of Detergent – Use full detergent
cup of fresh detergent in hard water. Use only
enough detergent to get good wash performance in
soft water.
Rinse Agent – Use rinse agent if spotting or drying
is a problem. A rinse agent will improve the water
sheeting action and drying performance.
Water Valve – (See Water Valve.)
Spray Arm – Check to be sure the spray arms spin
freely and jets are not clogged. Check to be sure
the middle spray arm water conduit is connecting
properly to the main conduit.
Drying – Water inlet temperature must be at least
120°F (48.9°C) for proper drying. Low water inlet
temperature will prevent proper convection air
movement and increase drying time substantially.
Compartment Lid
Sight Glass
Rinse Agent Cap
Latch
Detergent Compartment