Specifications

– 7 –
facing up. If the back surface of the panel is not
fl at, use the spacer pads provided. Drive the 1/2-in.
Phillips fl at-head screws through the brackets and
into the panel.
5. Install Custom Handle
A custom handle must be installed on the panel
before the panel is secured to the dishwasher door.
The handle should be installed so that it aligns with
adjacent drawer handles, or 4
1
/
2
inches maximum
from the top of the panel. Secure the handle in the
same manner as the cabinet handles. Screws must
be countersunk into the panel.
6. Install Assembled Panel
Secure the panel to the door by inserting the
top metal spacers and bottom brackets into the
matching slots on the dishwasher door and control
panel.
Make sure both metal spacers and both brackets
engage the slots.
Press the panel
against the
door and push
downward
until the metal
spacers and
brackets are
fully engaged
in the slots.
The panel
should align
evenly with
the top and sides.
Bracket
Spacer Pad
Spacer
Handle
4 1/2" Ma
x
from top
of panel
Custom
door panel
Screws must be counter-
sunk into panel
Custom
panel
(2) Brackets(2) Spacer Pads
(2) Metal spacers
(2) 3/4" Round-head
screws
(2) 1" Phillips
at-head
screws
(4) 1/2" Phillips
at-head
screws
Stand the dishwasher upright and open the
dishwasher door to remove the 2 plug buttons, one
on each side as shown.
Place the supplied 3/4-in. Phillips round-head
screws inside the
plastic sleeve and
drive through the
inner door and into
the custom panel.
Replace the 2 plug
buttons by pressing
them fi rmly back
into the plastic
sleeve.
Caution: Do not overtighten screws. Excessive
tightening of the screws could damage door edges.
7. Check Door Balance
To check the door balance, hold the top of the
dishwasher fi rmly. Check the door balance by
opening and closing the door.
If the door drops when released, increase the spring
tension. If the door rises when released, decrease
the spring tension.
Using a T25 Torx driver, adjust in the direction
shown. Adjust both sides equally.
Parts Supplied
Custom panel
Dishwasher
door
Increase
Decrease
Decrease
Increase
(2) Spacer Parts
(2) Brackets
(2) Metal Spacers
(2) 3/4-in. Round-
Head Screws
(2) 1-in. Phillips
Flat-Head Screws
(4) 1/2-in. Phillips
Flat-Head Screws