Use & care guide

Installation
Slai_le,vs Sleel I_lerior Di,shwa,sher
Step 3
Install
Water Inlet
Fittin,_s
• Install the 90 ° elbow onto the water inlet.
Use thread sealing tape or pipe thread
C()IIlp()/lI1 d,
• The 90 ° elbow should tace the left or right
side, depending on water line routing.
st@ 4
Install
powo cord
(g" used)
Skipthis step
If dishwasher
will be wired
direct.
• Install strain relief ontojmaction box and
tighten against incoming wires.
• Strip 1/2" insulation fl'om end of power
cord wires.
• Comaect incoming wires to dishwasher wires
using wire mlts of appropriate size.
• Comaect tile white to white, black to black
and incoming gro/md to green wire.
• Push all wires into thejm_ction box and
secm'e cover with screws onto dishwasher
ti'all/e.
Note: Tile power cord and connections II/[Ist
comply with tile National Electrical Code,
Section 429 and/or local codes and
ordinances.
IMPORTANT: The p(mer cord illt/st be no
longer than 6 fl fl'om thejmlction box to tile
plug. DO NOT PLUG IN PO_ ER CORD .AT
THIS TIME.
ScrewF
11