Use & care guide

Installation
Slaiule,vs Sleel Iulerior Di,shwa,sher
Step 8
[nstall
Drain Line
• Follow all local codes and ordinances.
Drain Line Preparation
• The dishwasher is supplied with a 78" hmg
corrugated drain hose.
• If the location requires a longer draiil hose,
add up to 42" length to the supplied hose.
Use 3/4" inside diameter hose and thin
wall copper coupler to join the hose ends.
Note: Total drain hoselength must not exceed 10 feet for
properdrain operation.
Drain Line Installation
• (_om_ect drain line to air gap, waste tee or
disposer using either method 1 or 2 as
previously determined.
• SecHre c(mnection using appropriate
clamps (not supplied).
• Make sm'e drain hose is not kinked.
Note: Removedrain plug beforeconnecting to disposer.
Dishwasher cannot drain if plug is left in place.
Method1 - AirGapwith WasteTeeorDisposer
Waste Tee Installation
DisposerInstallation
Method 2 - High Drain Loop
with Waste Tee or Disposer
Fasten to underside
Fasten to underside
__ ofcountertop
30" 30"
Waste Teelnstallation Disposerlnstallation
Step9
Connect
Electrical
(Fordirect
connectionto
housewiring)
lf house wiring is not 2-wire with a
__ ground wire, a ground must be provided
by the installer. When housewiring is
aluminum, besure to useU.L. listed
anti-oxidant compound and aluminum-
to-copper connectors.
Si le circuit de la maison n'a pasdeux
ills, plus un fil de terre, Vinstallateur
dolt installer un fil de terre. Quandles
ills de la maison sent en aluminium, il
faut prendre soin d'utiJiser une p_te
anti-oxydante et des connecteurs
aluminium a cuivre sur la liste UL.
Screw F
\
\
/
/
/
/
/
Verify that power is turned off at the source.
• Install a strain relief onto the junction box
and tighten against the incoming wires.
• Strip l/2" insulation fl'om end of incoming
wires.
• Use wire mlts of appropriate size and c(m-
nect white t()white, black to black and
incoming ground to green wire.
• Push all wires into the junction box and
place on dishwasher fl'ame. Secure with
screws "g".
13