Use & care guide
ZPF25 Custom Door Panel Kit
l/4" Tkick (ustom Door Pa_el
Step 2
Remove
Existin, g
Metal Door
• Open the door fllllv.,
Caution: One person should hold the door
while the other backs out s('rex_s to prex eat
the metal door fron/falling.
• Remove 6 screws on the inside the inner
door fl'ame, Retain screws,
• Remove the 2 screws with o-rings located in
the bottom center of the ironer door. Retain
screws and o-rings.
• [x)eIuove the ()liter door,
• Remove the 2 screws holding the center
door bracket to metal door,
• Retain bracket and insulation,
• Discard metal door,
Step 3
Assemble
Panel to
Door
• Place the supplied metal door Oll a fiat
s/li't_lce,
• Place the custom panel on top of the metal
door.
• Place supplied trim over the custom panel.
• Press trim to panel and install the color
matched screws provided. Install 3 screws
on each side and 9 screws on the bottom.
DoorTrim
Deco Panel
_orPanel
s@ 4
[nstall Door
C_nter
Bracket
• Turn the assembled door over with appear-
ance side down,
• Install center door bracket onto door using
original screws,
• Place insulation around support bracket,
Insulation
Install Screws
17