Use & care guide
ZPF25 Custom Door Panel Kit
l/4" Tkick Custom Door Pa_el
Step 5
fnstall
As sembled
Door onto
Dishwasher
• Locate the "(7' clips in the parts package.
Place one clip, flat side tip, oxer each of the
screw holes, 3 on each side of the door.
Note: Onepersonshould hold the doorwhile the other installs
screws to preventthe door assemblyfrom falling.
• Hold the assembled door to dishwasher
ironer door and slide tip against control
panel. Control panel has posts that should
engage the 9 holes in the top of the metal
door.
• Install the original center screws and
o-rings.
Note: Centerscrews and o-rings must be securelyfastened to
preventfuture leaks.
• Install original screx_ s to sides of imaer door
flame, 3 each side.
Step 6
[nstall
Door
5 rincs
The additional weight of the custom panel
may require that the heavy door springs be
installed.
Test Door Balance
• With one hand under the door, slowly open
the door filllv.
• Open and close the door to check t0r
proper balance. Correct door balance
should prevent the door fl'om raising by
itself fl'om a fifll open position and prevent
the door fl'om talling heavilv.
• If the door talls heavil}; damage will occur
ti'om repeated use.
• Install one or both new springs provided.
Install New Springs:
• Close and latch the dishwasher door.
• Locate door spring on left side of dish-
washer.
• Disengage the push rod guide by pushing
down on the guide and slowly pulling the
guide out of the mounting position.
• Carefldly release the tension on the spring
and remove the push rod guide fl'om the
rod.
• Remove the spring and replace with the
spring that has a yellow marking,
• Reassemble the push rod guide into the
original position,
• Test door balance,
• Install right side spring if needed,
18