Use & care guide

ZPF75 Custom Panel Kit
/4 Thick ( u,stom Door Panel
Step 2
Remove
Existing
Metal Door
• Open tile door flflly.
Caution: Oneperson should hold the door while the other
hacksout screws to preventthe metal doorfrom falling.
• Remove 6 screws on tile inside of tile
fi'ame. Retain screws.
• Remove tile 2 screws with o-rings located in
tile bottom center of tile door. Retain
screws and o-rings.
• Renlove tile door.
• Remove insulation and loam inserts,
discard metal door.
2 "0" Rings
Step 3
[nstall Door
Center Bracket
• Install new center door bracket onto door
using screws "Z'.
• Place insulation aroui]d support bracket.
ScrewZ
Supp!_:_!_acl<et
2-Depresslons_Fla t Face
i
i
&
Metallntegrated Door
Step4
Assemble
Custo' z"n
Pand
• Lay custom panel (m a fiat surtace, appear-
ance side down.
• Place tile new metal door panel onto tile
back of tile custom door panel. Align sides
and top edges.
• Drill 1/8" pilot holes, 3/8" deep, through
the metal panel and into tile custom panel,
3 each side.
• Secure custonl panel to metal door with
3 screws "X" on each side.
• Drill 1/4" pilot holes through tile top
return flange, approximately 1/4" deep.
Drill 1/8" Holes
(3 EachSide)
1
Drill 1/4"
Holes
ScrewX
_mPanel
2O