Use & care guide

ZPF75 Custom Panel Kit
3/4" Thick ( ustom Door Pa_el
Step 7
fnstall
Custom
7b&ick
• Slip toekick slides into guides by pulling out
the metal tabs.
• Hold custom panel against toekick slides
and mark screw hole locations.
• Remove toekick and drill 1/8" pilot holes.
• Remove toekick slides and secure panel to
slides with 2 screws each. Use screws "X'. If
panels are 1/2" thick, use caution when
driving these screws.
• Insert the assembled toekick into the
support brackets by pulling out the metal
tabs.
• Carefldl> slide assemblv back until it is
aligned with ac!jacent cabinetrv toekick.
• See product installation instructions to
reinstall the dishwasher.
• Carefldl> hold the door and open fldly,
Insure that door does not strike top of
toekick.
ScrewX
PullTabWhile Pushingtoel<ickin
2_