Owner`s manual

Installation Instructions
CONNECT WATER SUPPLY
• The water line should be flushed to clear any foreign
material before connecting to the icemaker.
• Connect the water line to the water supply tube
outside of the rear access cover.
Water
Supply
Line
CopperTubing:
• Use a standard plumbing female connector or union
for 1/4" copper tubing that can be purchased locally.
Coupling
(NotSupplied)
Nut
(Supplied)
\
Lineto
Icemaker
Ferrule
(NotSupplied)
\
Nut
(Supplied)
GE SmartConnectTM Tubing:
• Insert the molded end ofthe tubing into the icemaker
connection. _ghten the compression nut until it is
just hand tight.
• Tighten one additional turn with a wrench,
Overtightening can cause leaks!
• Make sure there are no sharp bends or kinks that
could restrict water flow.
• Slide the ice machine into its permanent location.
• To prevent
rattling, be sure
the copper tubing
does not touch
the side wall or
other parts inside
the cabinet.
• Open the shut-off
valve. Check for
leaks. -lighten
any connections
(including
connections
atthe valve)
if necessary.
Water Pan
Water Valve -
5-11/16" 4-5/8"
REVERSE THE DOOR SWING
IMPORTANT: Disconnect power to
the ice machine.
Tools Required:
• 1/4" and 5/16"wrench
• Flat putty knife
• Phillips screwdriver
Parts Supplied:
• 4 plug buttons
• 4 hinge screws
(on some models)
Parts Identification: (For Reference 0nly)
Hinge Pin Handle Screw
5/16" Hex Head Endcap Screw
Hinge Screw
• Remove the handle screws and lift off handle.
(On black and white models only.)
• Remove the hinge pin from the top hinge.
• Lift the door off of the bottom hinge. Place the hinge
pin back into the top hinge.
Reverse the door endcaps:
• Remove the screws and endcaps from the door,
top and bottom.
• Place the top endcap onto the bottom of the opposite
side of the door with the longflat side facing the
door front.
• Place the bottom endcap onto the top of the opposite
side of the door, with the longflat side facing the
door front.
• Setthe door aside.