Design Guide with Installation Instructions Outdoor/Indoor Refrigerator ZDOD240 monogram.
Safety Information BEFORE YOU BEGIN: WARNINGS: Read these instructions completely and carefully. • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be made by a qualified service technician. IMPORTANT – Save these instructions for local inspector’s use. IMPORTANT – Observe all governing codes and ordinances.
Important Information CONTENTS Important Information Caring for Your Stainless Steel ..................... 3 Tools, Hardware ................................................... 3 Design Guide The Installation Space ..................................... 4 Product Clearances and Location Requirements ...................................................... 4 Preparation for Built-In Under-Counter Installations Only ................................................
Design Guide THE INSTALLATION SPACE 23-3/4" The Outdoor/Indoor Refrigerator is factory set for a 110° door swing. When installed in a corner: • Allow 5-1/4″ min. clearance on the hinge side for the 90° door swing and to allow racks to slide out. • Allow 15″ minimum clearance on the hinge side for a full 110° door swing. • Test the door swing. Carefully open and close the door. Adjust if the door makes contact with cabinetry.
Installation Instructions GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR (CONT.) WARNING – IMPORTANT: PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.
Installation Instructions STEP 1 REMOVE PACKAGING STEP 3 CONNECT POWER • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. • If the refrigerator is used outdoors, plug the power cord into a GFCI receptacle. • Check to make sure power is on by opening the door to see if interior light turns on. • The interior fan runs at all times except when the door is open. See the the Owner’s Manual for further explanation.
Installation Instructions STAINING WOOD DRAWER FRONTS The drawer fronts are unfinished cherry wood. During use, oil from hands may accumulate and stain the wood. • The drawer fronts may be stained and sealed to match adjacent cabinetry. • Apply the stain and sealer according to the manufacturer’s instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product.
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Pub. No. 31-51542-2 Part No. 197D5893P001 08-07 JR Printed in Slovenia GE Consumer & Industrial Appliances General Electric Company Louisville, KY 40225 ge.
