Design Guide with Installation Instructions Outdoor/Indoor Refrigerator ZDOD240 monogram.
Safety Information BEFORE YOU BEGIN: WARNINGS: Read these instructions completely and carefully. • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be made by a qualified service technician. IMPORTANT – Save these instructions for local inspector’s use. IMPORTANT – Observe all governing codes and ordinances.
Important Information CONTENTS Important Information Caring for Your Stainless Steel....................... 3 Tools Required....................................................... 3 Design Guide The Installation Space........................................ 4 Product Clearances and Location Requirements......................................................... 5 Preparation for Built-In Under-Counter Installations Only ................................................
Design Guide THE INSTALLATION SPACE (cont.) THE INSTALLATION SPACE Flush Installation 1/2" Filler panel or cleat to be set back even with front of case. NOTE: Handle and handle standoff depth is 2-7/8" Free-Standing – Use canopy top Built-In – Remove canopy top (if needed) CABINET Front edge of product case Front face These products will fit flush to adjacent cabinets when installed with a 1/2" filler panel or cleat.
Design Guide PRODUCT CLEARANCES AND LOCATION REQUIREMENTS PREPARATION FOR BUILT-IN UNDER-COUNTER INSTALLATIONS ONLY The Outdoor/Indoor Refrigerator is factory set for a 110° door swing. When installed in a corner: • Allow 5-1/4" min. clearance on the hinge side for the 90° door swing and to allow racks to slide out. • Allow 15" minimum clearance on the hinge side for a full 110° door swing. • Test the door swing. Carefully open and close the door. Adjust if the door makes contact with cabinetry.
Installation Instructions GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR (CONT.) IMPORTANT: PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.
Installation Instructions STEP 4 SLIDE PRODUCT INTO THE CUTOUT STEP 2 LEVEL • Use an adjustable wrench to turn and raise or lower the leveling legs. • Measure floor to countertop height inside the opening. Adjust leveling legs until the product is approximately 1/8" less than countertop height. CAUTION: Do not push against the door with your knees. Do not push or lift the unit by the door handle. Damage may occur! ATTENTION : Ne poussez jamais la porte avec vos genoux.
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Pub. No. 31-51542-3 Part No.