Owner`s manual

ZXADJB30PSS,ZXADJB36PSS,ZXADJB48PSSAccessorg Installation
ACCESSORIES--30" TO 36" ADJUSTABLE BACKSPLASH (not included)
- WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected by a backsplash constructed
of non-combustible material.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: OBSERVEALL GOVERNING CODES
AND ORDINANCES.
NOTETO INSTALLER:Be sure to leave these
instructions with the Consumer.
NOTETO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
• This backsplash adjusts to fit the space between
the top ofthe range and the bottom of the hood,
from 30" Min. to 36" Max. height.
• Maximum shelf load-bearing weight is40 Ibs.
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-1S and #2 Phillips screwdrivers
• Drill with 3/32" and 9/64" bits
• Safety glasses
• Level TopCover
• Pencil with Shelf
TopWall
Support
This Kit Includes
• Top wall support
• Bottom wall support
• Top cover with shelf
• Bottom cover
• Hardware package with
BottomWall Support
- 9 Stainless Steel Torx 15 #8
self-tapping screws
- 9 Phillips #2 pan head wood #10 screws
- 3 Stainless Steel #2 truss head
#10 screws (for alternate
installation method)
Hardware
Package
INSTALL THE WALL SUPPORT PANELS
WARNING:The wall support panels
must be securely fastened to the wall. Failure to
do so could result in damage or personal injury.
IMPORTANT:Thisbacksplosh is designed to cover the wall
between the bottom of the hood and the top of the range.
The vent hood should be installedover the rongetop or
range before installing this backsplGsh.
• Install and levelthe Ronge/Rongetop according
to the product installation instructions.
• Removebocksplosh packaging and protective film.
• Locatewall studs on each side.Where studs ore not
available, plan to use wall anchors (not provided).
• Usea level to pencil 2 horizontal lines on the wall,
one 3_/8"below the vent hood and the other 1/8" above
the Range/Rangetop.This1/8" space allows the cover
panels to overlap the wall supports.
• Secure the top wall support panel to the wall with 4 wood
screws, through the outermost studs.
• Use4 wood screwsto securethe bottom wall support
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels
will be covered bg the top cover with shelf.
Securethe top
panelto the wall
with 4 wood
screws
Wood
Screws
Secure
the bottompanel
to the wall with
4 wood screws
19