Owner`s manual

– 30 –

Surface Components

Control Panel

It is necessary to remove the control panel from the

range or rangetop chassis and place it in the service

position to access certain components.

To place the control panel in the service position:

Note: It will be necessary to pull the rangetop

approximately 10 inches out from its installation.

1. Remove left and right side grates, surface

burner knobs, grill and griddle control knobs.

2. On range models:

a. Remove the 2 Phillips-head screws that

attach the griddle control bezel to the

control panel.

b. Remove the 2 Phillips-head screws that

attach the griddle control to the manifold

bracket.

5. Remove the Phillips-head screw at each front

corner that attaches the front of the side trim to

the control panel.

3. Remove the 2 Phillips-head screws within each

bezel that attach the bezel to the manifold

brackets.

Bezel Screw

Control Screw

4. Remove the T-15 Torx screws from the bottom

of the control panel.

WARNING: Sharp edges may be exposed when

servicing. Use caution to avoid injury. Wear Kevlar

gloves or equivalent protection.

Note:

A ground wire at each end of the panel allows •

the panel to be lowered without falling.

Before lowering, protect the bottom of the front •

panel from scratches caused by the lock motor

arm (range models) or front frame edge.

If the range has a grill, use caution when •

lowering the control panel to prevent damage to

the switches mounted at the bottom of the grill

valve.

(Continued next page)