Installation Instructions

3
PARTS SUPPLIED IN
INSTALLATION PACKAGE:
• Drain hose extension
• Hose Clamp
• 2 mounting brackets for wood countertop or side
cabinets
• Toekick Insulation
• 6 Phillips-Head screws to secure dishwasher to
underside of countertop or to side cabinets
• Literature, samples and/or coupons
TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 1/4” and 5/16” nutdriver
• T25 torque driver
• 6” adjustable wrench
• Gloves
• Safety glasses
• Flashlight
• Bucket to catch water
when flushing the line
• Level
• Measuring tape
• Carpenter’s square
For New Installations Only:
• Tubing cutter
• Drill and appropriate bits
• Hole saw set
MATERIALS YOU WILL NEED:
• UL-listed wire nuts (3)
• Thread Seal Tape
• 90° elbow (3/4” hose internal thread on one end,
opposite end sized to fit water supply)
Materials For New Installations Only:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• Electrical cable or Power Cord Kit WX09X70910 (5’ 4”
long) or WX09X70911 (7’ 9” long) depending on your
installation.
• Screw-type hose clamp(s)
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Hot water line–3/8” minimum, copper tubing
(including ferrule, compression nut) or Monogram
Part # WX28X326, flexible braided hose.
Installation Preparation
Hole Saw Set
Measuring Tape
Tubing Cutter
Drill and Bits
Phillips-Head
Screwdriver
1/4” and 5/16”
Nutdriver
6” Adjustable
Wrench
Gloves
Carpenter’s
Square
Level
Drain Hose
Extension
Literature
Hot Water Line,
Ferrule and
Compression Nut
Strain Relief
Hose Clamp(s)
Waste Tee
Electrical Cable
(or Power Cord,
if applicable)
Wire Nuts (3)
Hand
Shut-Off
Valve
Air Gap
Thread Seal
Tape
Safety Glasses
Flashlight
Bucket
T25 Torque
Driver
Hose Clamp
Toekick Insulation
Phillips-Head
Screws
90° Elbow
Mounting Brackets