GE Monogram Installation Instructions Professional Gas Cooktops 48" Natural Gas Models ZGU48N4G ZGU48N6R ZGU48N6D 48" lAP Gas Models ZGU48L4G ZGU48L6R ZGU48L6D 36" Natural Gas Models ZGU36N6 ZGU36N4R ZGU36N4D 36" lAP Gas Models ZGU36L6 ZGU36L4R ZGU36L4D ®
Betore you begin--Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector's use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer: NOTE TO CONSUMER: i[,lva,_lmm_I,t1"his appliance Keep must be properly these instructions grounded. See "Electrical For Monogram local service in your area, 1-800-444-1845. For Monogram Service in Canada, Call 1-888-880-3030.
Design Information Pr@ssional Models" Available These cooktops are factory set far either natural gas or liquid propane gas. Order the model for your installation situation.
Design Information Pr@ssional Gas Cooktops Product Dimensions R &t,l oa 18"Min. 48" 36" Min. to Combustible 12"Min. to Material From Combustible Cooking Material / EachSide_ Surface Instructions Wide Models L\ 22-3/4"Min. \ \ '\ x \ \ o j 18" Min. 36" 36"Min. to Combustible 12"Min. to Material From Combustible Cooking Material | Surface EachSide1- Installation Instructions Wide Models 2'_ _"_ i34 7/8"_22_3/4,,Mi n CookmgSufface II \ \ " \ Electric/Gas Supply _:_v / _'/_ \ ,
Installation Preparation Pro/essional Installation Options These cooktops can be installed in standard 24" or deeper 25" cabinets. • In 24" deep cabinets, the front of the cooktop will project approximately 1-7/8" beyond the fi'ont of the countertop. • In 25" deep cabinets, the cooktop will be flush with the fi'ont of the countertop. Gas Cooktops •The stainless surface of the cooktop will be 1/2" higher than adjacent countertop. • Cooktop fits flush to rear of cutout, no additional support is required.
Installation Preparation Profi_ssional 7bols & Materials .%qui, d: Powgr Supply Locations • Saw • • • • • • • Gas Cookt@s • Gas-resistant pipe.joint sealant • 5 tbot, 5/8" AGA-certified flexible metal gas supply line. -If required by local codes, use solid pipe fittings. Note: Purchase new flexible line. DO NOT Measuring tape Carpenter's square Pipe and fittings as required. Manual gas line shut-off valve. Gas pressure regulator (supplied) Large flat-blade screwdriver Pipe wrench USE OLD, LINE.
Installation Pr@ssional Use a hand-truck Remove Packaging to move • Remove knobs. the grates • Flatten the carton and use a piece as a pad on the bottom and back of the hand-truck. this cooktop. Before moving the cooktop indoors: • Remove outer carton and packing. • Remove the straps holding the cooktop skid. and drawers below Gas Cooktops to the the • Remove grill and/or griddle covers. DO NOT ATTEMPT TO REMOVE A GRILL OR GRIDDLE ASSEMBLY.
Installation Professional • Lower the cooktop into the opening. Make sure the cooktop is evenly seated and supported. A side fi'ame gasket will seal the cooktop to the countertop. • "L" brackets with screw's are provided m secure the cooktop to the countertop or to acliacent cabinetry. -Alternate screw" hole locations on the sides Install the Cooktop of the cooktop allow fbr varying thicknesses of countertops or side cleats. • Select the bracket location, secure the bracket to the cooktop with 2 screw's.
Installation Pr@ssional Plug power cord into properly receptacle. Gas Cooktops grounded Connect Elecbical Assemble Burners_ • Replace the burner bowls and burner caps. • Adjustments should not be required, unless vibration during transit or variations in local gas supply make minor adjustments necessary. Check CAUTION: Burner acljustments must be made by a qualified technician at the time of installation. Extreme care should be used if Ignition acliustments • Burner are made after installation.
Installation Pro/essional Check Adjustable low setting The open top burners and grill valves have an adjustable low setting. Each valve is individually tested and adjusted before it is shipped. Minor adjustments may be required due to fluctuations in local gas pressure. Adjustments to increase or decrease gas flow may be necessary. Ignition • Turn (continued) position. • Once lit, turn st° 7 Assemble Burners, knob counter-clockwise the position. • Remove the knob.
Notes Pr@ssional Gas Cooktops I1
NOTE: Whbe berferbe% k_stallat[onsdescribedk_this book, safety glassesor gogglessbeuId beworn NOTE: PI oduct Electri_ The] s_{2iecL Monogram: General Electric Cempany Louisville, KY 43225 inl provemerlt e_}_, to change nla_'_i_]s_ wlthouL is a con tlnuing appea_ aJ_ e &_ld sp_c[fi_ endt a_ol at _,enel _ttlo_ls al air" no[_c_ Pub.No.49-8812-4 Dwg.No. 164D3333P056 {ND.