Installation Instructions

34
STEP 8 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to
a 90° opening. A 130° door swing is available for
standard installation only. If used for flush installation,
damage will occur to wood panels. Skip this step if
door opening is satisfactory for your installation
situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
• Reinstall the wire cover trim.
Pin Location
for 90°
Door Swing
Pin Location for
130° Door Swing
(Standard Only)
Pin Location
as Shipped for
115°
Door Swing
Installation Instructions - Stainless Steel Installation
STEP 7 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping. When the anti-tip bracket cannot be used,
this alternate method can be used to prevent the
refrigerator from tipping.
• Raise the grille panel to access case trim.
• Use a 3/16” bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16” bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4” (1.90 cm)
min. wood brace. The brace spanning the enclosure
must be securely fastened to cabinets on both sides.
• Install four, 1-1/2” (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.
Top Case Trim
Install four 1-1/2” drywall screws through
trim and into soffit or 3/4” min. wood brace
3/4” Min.
Side View Top
Case Trim
Raise grille panel to
stop position
Drive screws through case
trim into adjacent cabinets
Remove grille screws
31-1000452 Rev. 1