Installation Instructions

9
1/4” (0.63 cm) FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be cut to the
dimensions shown. The panels will slide into the frame on the door,
drawer and grille.
If the custom panel is less than 1/4” thick and if it fits loosely in the
door frame, it can be backed up with a piece of filler material or foam
tape to improve the fit.
Spacer Panel
Backer Panel
Overlay Panel
Framed Panel Dimensions
1/4” (0.63 cm)
Framed Panel
A (Width) B (Grille Height) C (FF Height) D (FZ Height)
33-7/8”
(86.04 cm)
8-7/8”
(22.54 cm)
46-1/16”
(101.76 cm)
21-7/8”
(55.56 cm)
Overlay Panel Dimensions
1/4” (0.63 cm) Backer
Panel
A (Width) B (Grille Height) C (FF Height) D (FZ Height)
33-7/8”
(86.04 cm)
8-7/8”
(22.54 cm)
46-1/16”
(116.99 cm)
21-7/8”
(55.56 cm)
0.10” (0.25 cm) Spacer
Panel
32-1/2”
(82.55 cm)
7-5/8” (
20 cm)
44-11/16”
(113.51 cm)
20-1/2”
(52.07 cm)
3/4” (1.9 cm) Overlay
Panel
34-1/8”
(96.67 cm)
9” (22.86 cm) 46-5/16”
(117.63 cm)
22”
(55.88 cm)
NOTE: Left-to-right offset is not always equal to top-to-bottom offset.
1/4"
Panel
Door
5/16"
Trim
Reveal
IMPORTANT NOTE: Maximum total panel
weight:
• Fresh food door panel – 58 lbs. (26.31 kg)
• Freezer drawer panel – 28 lbs. (12.70 kg)
• Grille Panel – 11 lbs. (4.99 kg)
IMPORTANT NOTE: Maximum
total weight for the assembled
panels:
• Fresh food door panel – 58 lbs.
(26 kg)
• Freezer drawer panel – 28 lbs.
(13 kg)
• Grille Panel – 11 lbs. (5 kg)
Design Guide - Standard Installation
3/4” OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may be
installed on trimmed models. The overlay panel must
be secured to a 1/4” (0.63 cm) thick backer panel which
slides into the trim. A spacer panel 0.10” (0.25 cm) thick
must be placed between the overlay and backer panel.
Assemble the panels with glue and screws.
• Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
• Center the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
31-1000452 Rev. 1