Design Guide with Installation Instructions Double-Drawer Built-In Refrigerator ZIDI240 ZIDS240 monogram.
Safety Information BEFORE YOU BEGIN: WARNING: • Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be made by a qualified service technician. Read these instructions completely and carefully.
Important Information CONTENTS Important Information Tools Required ............................................3 Parts Required..............................................3 Caring for Your Stainless Steel ............3 Design Guide (for ZIDI240) The Installation Space ..............................5 Product Clearances....................................5 Side-by-Side Installations ......................5 Design Guide (for ZIDS240) The Installation Space ..............................
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Countertop Double-Drawer 22" min. Clearance for Door Opening 2-1/2" min. Allow 2-1⁄2" min. clearance between Double-Drawer and adjacent cabinet, wall or other appliances. Allow 22" min. clearance from the front for drawer opening.
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Countertop Double-Drawer 23-1/8" min. Clearance for Door Opening 2-1/2" min. Allow 2-1⁄2" min. clearance between Double-Drawer and adjacent cabinet, wall or other appliances. Allow 23-1⁄8" min. clearance from the front for drawer opening.
Installation Instructions STEP 1 REMOVE PACKAGING STEP 2 INSTALL CUSTOM 3/4" DRAWER PANELS AND HANDLES (CONT.) • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. (ZIDI240 model only) CAUTION: Install custom drawer panels and handles: • Open drawers. • Remove 2 screws holding each trim; lift trims off. Retain screws. Small objects are a choke hazard for children. Remove and discard any parts not used.
Installation Instructions STEP 3 LEVEL STEP 2 INSTALL CUSTOM 3/4" DRAWER PANELS AND HANDLES (CONT.) Use an adjustable wrench to turn and raise or lower the leveling legs. • Measure floor to countertop height inside the opening. Adjust leveling legs until the product is approximately 1/8" less than countertop height. (ZIDI240 model only) • Reinstall the side trims using the trim screws removed earlier.
Installation Instructions STEP 4 CONNECT POWER STEP 6 SET TEMPERATURE CONTROLS • Connect power cord plug to a properly grounded receptacle. • Check to make sure power is on by opening a drawer to see if interior light turns on. • The interior fan runs all the time except when a drawer is open. See the Owner’s Manual for further explanation of the fan. • The temperature controls are preset. Refer to the Owner’s Manual for more information. Allow 12–24 hours for the temperature to stabilize.
