Design Guide with Installation Instructions Double-Drawer Built-In Refrigerator ZIDI240 ZIDS240 monogram.
Safety Information BEFORE YOU BEGIN: WARNING: Read these instructions completely and carefully. • Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be made by a qualified service technician.
Important Information CONTENTS Important Information Tools, Hardware ........................................3 Parts Required..............................................3 Caring for Your Stainless Steel ............3 Design Guide (for ZIDI240) The Installation Space ..............................5 Product Clearances....................................5 Side-by-Side Installations ......................5 Design Guide (for ZIDS240) The Installation Space ..............................4 Product Clearances..
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Countertop Double-Drawer Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" 24" 9" 9" Max. Max. 22" min. 1-1/2" 1-1/2" 23-3/4" Min.
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Countertop Double-Drawer Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" 24" 9" 9" Max. Max. 23-1/8" min. 1-1/2" 1-1/2" 23-3/4" Min. Clearance for Door Opening 2-1/2" min. 34-1/4" to 34-3/4" NOTE: Handles not supplied.* 24-7/8" Allow 2-1⁄2″ min.
Installation Instructions STEP 1 REMOVE PACKAGING STEP 2 INSTALL CUSTOM 3/4″ DRAWER PANELS AND HANDLES (CONT.) • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. (ZIDI240 model only) CAUTION: Small objects are a choke hazard Install custom drawer panels and handles: • Open drawers. • Remove 2 screws holding each trim; lift trims off. Retain screws. for children. Remove and discard any parts not used.
Installation Instructions STEP 3 LEVEL STEP 2 INSTALL CUSTOM 3/4″ DRAWER PANELS AND HANDLES (CONT.) Use an adjustable wrench to turn and raise or lower the leveling legs. • Measure floor to countertop height inside the opening. Adjust leveling legs until the product is approximately 1/8″ less than countertop height. (ZIDI240 model only) • Reinstall the side trims using the trim screws removed earlier.
Installation Instructions STEP 4 CONNECT POWER STEP 6 SET TEMPERATURE CONTROLS • Connect power cord plug to a properly grounded receptacle. • Check to make sure power is on by opening a drawer to see if interior light turns on. • The interior fan runs all the time except when a drawer is open. See the Owner’s Manual for further explanation of the fan. • The temperature controls are preset. Refer to the Owner’s Manual for more information. Allow 12–24 hours for the temperature to stabilize.
