Specifications

Installation Instructions
ISTEP21 INSTALLCUSTOM3/4"
DRAWER PANELS AND
HANDLES ICONT.I
(ZID1240 model onlgl
• Reinstall the side trims using the trim screws removed
earlier.
• Placethe brushed decorative covers over the side trim
to hide the screw heads. Ensure side trim is aligned top
to bottom and front to back. Snap into place.
NOTE: Forshipping purposes, the brushed decorative
cover will be secured to the front of the unit.
ISTEP 31 LEVEL
Usean adjustable wrench to turn and raise or lower the
leveling legs.
• Measure floor to countertop height inside the opening.
Adjust leveling legs until the product is approximately
1/8" less than countertop height.
jjJ'_ /
TurnRighttoLower
TurnLeftto Raise
INSTALLATION TIP:
Measure floor to underside of countertop inside
the opening.
• If the room floor is higher than the floor inside the
opening, adjust the rear leveling legs to approximatelg
1/8" less than the opening height. Screw front leveling
legs all the wag in to shorten the height at the front.
This will ollow gou to slightlg tip the unit into the
opening. Once the unit is in the correct position,
the front legs con be adjusted to level the product.