INSTALLATION INSTRUCTIONS Double-Drawer Built-In Refrigerator MONOGRAM.
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer. • Note to Consumer – Keep these instructions with your Owner’s Manual for future reference. WARNING If you received a damaged refrigerator, you should immediately contact your dealer or builder.
Consignes de Sécurité AVERTISSEMENT Risque d’explosion. Conservez les matériaux et vapeurs inflammables de votre réfrigérateur. Le non-respect de cette instruction peut entraîner un risque d’incendie, d’explosion ou de décès. AVERTISSEMENT Pour réduire le risque d’étouffement pendant l’installation de ce produit, ne pas laisser les petites pièces à la portée des enfants âgés de moins de 3 ans. BRANCHEMENTS ÉLECTRIQUES AVERTISSEMENT Risque d’électrocution.
Important Information CONTENTS Important Information Tools, Hardware ....................................................... 4 Parts Required .......................................................... 4 Caring for Your Stainless Steel ................................. 4 Design Guide (for ZIDS240) The Installation Space ............................................... 5 Product Clearances ................................................... 5 Side-by-Side Installations .........................................
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" 9" 9" Max. Max. Countertop Double-Drawer 24" 1-1/2" 1-1/2" 23-3/4" Min. 22" min. 34-1/4" to 34-3/4" Clearance for Door Opening 2-1/2" min.
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Double-Drawer Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" Countertop 24" 9" 9" Max. Max. 23-1/8" min. 1-1/2" 1-1/2" 23-3/4" Min. Clearance for Door Opening 2-1/2" min. 34-1/4" to 34-3/4" NOTE: Handles not supplied.
Installation Instructions STEP 1 REMOVE PACKAGING AND INSTALLATION PARTS • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. WARNING Small objects are a choke hazard for children. Remove and discard any parts not used. AVERTISSEMENT Les petits objets peuvent étrangler les enfants. Il faut jeter toutes les pièces qui ne sont pas utilisées.
Installation Instructions STEP 2 INSTALL CUSTOM 3/4” DRAWER PANELS AND HANDLES (CONT.) STEP 2 INSTALL CUSTOM 3/4” DRAWER PANELS AND HANDLES (CONT.) (ZIDI240 model only) (ZIDI240 model only) • Reinstall the side trims using the trim screws removed earlier. Install custom drawer panels and handles: • Open drawers. • Remove 2 screws holding each trim; lift trims off. Retain screws.
Installation Instructions STEP 3 LEVEL Use an adjustable wrench to turn and raise or lower the leveling legs. • Measure floor to countertop height inside the opening. Adjust leveling legs until the product is approximately 1/8” less than countertop height. Turn Right to Lower Turn Left to Raise INSTALLATION TIP: Measure floor to underside of countertop inside the opening.
Notes 10 31-51545-6
Notes 31-51545-6 11
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at Monogram. Therefore, materials, appearance and specifications are subject to change without notice. 31-51545-6 01-20 GEA Monogram.