INSTALLATION INSTRUCTIONS with Design Guide Double-Drawer Built-In Refrigerator Monogram.
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer. • Note to Consumer – Keep these instructions with your Owner’s Manual for future reference. If you received a damaged refrigerator, you should immediately contact your dealer or builder.
Consignes de Sécurité AVERTISSEMENT Risque d’explosion. Conservez les matériaux et vapeurs inflammables tels que l’essence à l’écart de votre réfrigérateur. Le non-respect de cette instruction peut entraîner un risque d’incendie, d’explosion ou de décès. AVERTISSEMENT Pour réduire le risque d’étouffement pendant l’installation de ce produit, ne pas laisser les petites pièces à la portée des enfants âgés de moins de 3 ans. BRANCHEMENTS ÉLECTRIQUES AVERTISSEMENT Risque d’électrocution.
Important Information CONTENTS Important Information Tools, Hardware ....................................................... 4 Parts Required .......................................................... 4 Caring for Your Stainless Steel ................................. 4 Design Guide (for ZIDS240) The Installation Space ............................................... 5 Product Clearances ................................................... 5 Side-by-Side Installations ........................................
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" 9" 9" Max. Max. Countertop Double-Drawer 24" 1-1/2" 1-1/2" 23-3/4" Min. 22" min. 34-1/4" to 34-3/4" Clearance for Door Opening 2-1/2" min.
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are designed to be built-in only. They cannot be used free-standing. When installed in a corner: Double-Drawer Locate Outlet 8-1/2" 10-1/2" 34-1/2"-35" Countertop 24" 9" 9" Max. Max. 23-1/8" min. 1-1/2" 1-1/2" 23-3/4" Min. Clearance for Door Opening 2-1/2" min. 34-1/4" to 34-3/4" NOTE: Handles not supplied.
Installation Instructions STEP 1 REMOVE PACKAGING AND INSTALLATION PARTS • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. WARNING Small objects are a choke hazard for children. Remove and discard any parts not used. STEP 2 INSTALL CUSTOM 3/4” DRAWER PANELS AND HANDLES (CONT.) (ZIDI240 model only) Install custom drawer panels and handles: • Open drawers. • Remove 2 screws holding each trim; lift trims off. Retain screws.
Installation Instructions STEP 2 INSTALL CUSTOM 3/4” DRAWER PANELS AND HANDLES (CONT.) (ZIDI240 model only) • Reinstall the side trims using the trim screws removed earlier. • Place the brushed decorative covers over the side trim to hide the screw heads. Ensure side trim is aligned top to bottom and front to back. Snap into place. STEP 3 LEVEL Use an adjustable wrench to turn and raise or lower the leveling legs. • Measure floor to countertop height inside the opening.
Installation Instructions STEP 4 CONNECT POWER • Connect power cord plug to a properly grounded receptacle. • Check to make sure power is on by opening a drawer to see if interior light turns on. • The interior fan runs all the time except when a drawer is open. See the Owner’s Manual for further explanation of the fan. STEP 6 SET TEMPERATURE CONTROLS • The temperature controls are preset. Refer to the Owner’s Manual for more information. Allow 12–24 hours for the temperature to stabilize.
Notes 10 31-51545-5
Notes 31-51545-5 11
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at Monogram. Therefore, materials, appearance and specifications are subject to change without notice. 31-51545-5 02-19 GEA Monogram.