Specifications

ZIFI240HIIMONOGRAM FRESH-FOOD REFRIGERATOR
Product Specification Revised 1/18
INSTALLATION
34 1/2"
(87.6) min
underside of
counter to floor
35" (88.9) max
24" (61.0)
min cutout depth
CUTOUT INSTALLATION
SIDE VIEW
INSTALLATION CUTOUT
FRONT VIEW
ELECTRIC
Door
1/4" Backer Panel
.10" Spacer Panel
Trim
3/4" Overlay Panel
A" (aa)
B"
(bb)
23 3/4" (60.3)
min standard
24 3/4" (62.9)
min flush inset
10 1/2" (26.7)
9"
(22.9) max
1 1/2" (3.8)
ZIFI240PII
Installation Space: This module
can be installed beneath a
countertop or can be used free-
standing.
For a standard installation of
stainless steel unit: The product
must be installed so that the
front face will project 1-5/8"
forward of adjacent cabinets.
For a flush installation of
stainless steel unit: Install a
1" wide filler strip on the hinge
side. The width of the opening
must be 24-3/4" min. wide.
See installation instructions for
details.
Location Requirements: All
Monogram Refrigeration
Modules may be closed in on
the top and sides as long as
the front is unobstructed for air
circulation and door swing.
• Do not install these products
where the temperatures will
go below 55° F (13 C) or above
90° F (32 C).
• Products must operate from
separate properly grounded
receptacles.
• These products are not
designed to be stacked one
over the other.
See installation instructions for
side-by-side information.
NOTES
PRODUCT DIM. A
ZDWI240, ZDB1240 1"
ZDWR240, ZDBR240 1"
ZIB1240, ZIF1240 1"
ZIFS240, ZIBS240 1/4"
ZDOD240 1-1/4"
PRODUCT DIM. A
ZDWI240, ZDB1240 2"
ZDWR240, ZDBR240 1-3/4"
ZIFS240, ZIF1240 1-5/8"
ZDOD240 1-7/8"
ZIB1240, ZIBS240 2-5/8"
CABINET CABINET
Dim. A
Front Edge of
Product Case
Front Face
Standard
Installation
110º
120º
In a standard installation, the
product will project forward of
adjacent cabinets. See Dim. A.
23 3/4" min.
CABINET CABINET
These products will fit flush to adjacent
cabinets when installed with a Dim. A - width
filler panel or cleat. The filler panel should be
recessed or set back behind the door and
even with the front edge of the product case.
110º
120º
Flush
Installation
Filler panel or cleat to be set
back even with front of case.
Front Edge of
Product Case
Dim. A
Front Face
24 3/4" min. width
stainless steel models
REFRIGERATION MODULES, TOP VIEW