Owner's Manual

20
Installation Instructions - Standard Installation
STEP 10A INSTALL OVERLAY PANELS
CUSTOM HANDLES
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel into
the trim. Custom Handle Trim Kit is provided with this unit.
Fresh Food Doors
Beginning with the right fresh food door, slide assembled
door panel into the trim on the door.
Place the custom handle trim against the side of the
refrigerator door, aligned top to bottom. The holes in the
trim should align to the holes in the door.
Attach the custom handle trim with the 4 screws previously
removed.
Remove the paper backing from the mylar tape on the
flange trim cover. Place the flange trim cover onto the
custom handle trim. The tape will help hold the cover in
place. Use shims at the top and bottom of the flange trim
cover, between it and the door, making sure the flange
trim cover fits flush to the custom handle trim. Using the
4 screws provided in custom handle trim kit, secure the
flange trim cover with 2 screws at top and 2 screws at
bottom.
Repeat these steps with the left fresh food door.
Freezer drawer
Slide the assembled panel into the drawer trim.
Secure the original drawer trim using the original round
head trim screws.
IF YOU ARE INSTALLING FRAMED PANELS,
GO TO STEP 10.
Install door and drawer panels:
Open door to 90°. Remove the 4 Phillips head screws
from the door handle.
Remove handle. Retain all screws.
Slide overlay panel into the door trim.
Secure the handle to the door using the screws
removed earlier.
Follow the same procedures to install the second door
panel.
For freezer drawer, once panel is installed, use rear
4 screws holes to install the top freezer door trim and
align the handle to the remaining screw holes.
Supplied handle shown
2-sided
Mylar
Tape
Flange
Trim
Cover
Door
Handle
Trim
Door Trim
and
4 Screws
Double-Sided
Mylar Tape
Located
on Back of
Flange Trim
Cover
Shims
Flange Trim
Cover and
4 Screws
Custom Handle
Trim and 4 Screws
Shims
31-49141 Rev. 2