Owner's Manual

21
Installation Instructions - Standard Installation
STEP 12 CONNECT POWER
• Check to be sure the power cord is plugged into the
receptacle.
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights
are on.
• The temperature controls are preset at 37°F (2.78°C)
for the fresh food section and 0°F (-17.78°C) for the
freezer.
• Allow 24 hours to stabilize before making adjustments.
STEP 11 CONNECT WATER
SUPPLY
WARNING
Connect to potable water supply
only.
AVERTISSEMENT
Raccordez l’appareil à une
alimentation d’eau potable seulement.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on
to flush debris from
line. Run about
a quart of water
through tubing into
a bucket, then shut
off water.
Copper Tubing:
• Slip a 1/4” nut and
ferrule (provided)
over both ends of
the copper tubing.
Insert tube into the
union fitting on the
unit and tighten
nut to union.
• Turn on the water to check for leaks.
SmartConnect
™
Tubing:
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
™
Refrigerator Tubing kits.
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
• Insert the molded end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not interfere
with drawer closing or toekick installation.
Refrigerator
Water Supply
House
Water Supply
Electrical
Outlet
Raise
Grille
Panel
STEP 13 START ICEMAKER
CAUTION
Avoid contact with the moving parts of
the ejector mechanism, or with the heating element
(located on the bottom of the icemaker) that releases the
cubes. Do not place fingers or hands on the automatic
ice making mechanism while the freezer is plugged in.
ATTENTION
Évitez tout contact avec les pièces mobiles
du mécanisme d’éjection, ou l’élément chauffant (situé dans
le bas de la machine à glaçons) qui libère les glaçons. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque le congélateur est
branché dans la prise électrique.
PRECAUCIÓN
Evite el contacto con las partes en
movimiento del mecanismo expulsor o con el elemento de
calefacción (ubicado en la parte inferior de la máquina de
hielo) que expulsa los cubos. No coloque los dedos ni las
manos en el mecanismo de la máquina de hielo automática
mientras el freezer se encuentre enchufado.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, set the switch to O (OFF).
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
ON
OFF
31-49141 Rev. 2