Owner's Manual

37
STEP 10 INSTALL GRILLE PANEL
• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel and into the
trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
Installation Instructions - Flush Inset Installation
STEP 11 INSTALL ASSEMBLED PANELS
• Install custom handles according to the manufacturer’s
instructions. Custom handle trim kit is provided with this
unit.
FRESH FOOD DOORS
• Beginning with the right fresh food door, slide
assembled door panel into the trim on the door.
• Place the custom handle trim against the side of the
refrigerator door, aligned top to bottom. The holes in the
trim should align to the holes in the door.
• Attach the custom handle trim with the 4 screws
previously removed.
• Remove the paper backing from the mylar tape on the
flange trim cover. Place the flange trim cover onto the
custom handle trim. The tape will help hold the cover
in place. Use shims at the top and bottom of the flange
trim cover, between it and the door, making sure the
flange trim cover fits flush to the custom handle trim.
Using the 4 screws provided in custom handle trim kit,
secure the flange trim cover with 2 screws at top and 2
screws at bottom.
• Repeat these steps with the left fresh food door.
FREEZER DRAWER
• Slide the assembled panel into the drawer trim.
• Secure the original drawer trim using the original round
head trim screws.
2-sided
Mylar
Tape
Flange
Trim
Cover
Door
Handle
Trim
Door Trim and
4 Screws
Shims
Flange Trim Cover
and 4 Screws
Custom Handle
Trim and 4 Screws
Shims
Double-Sided
Mylar Tape
Located
on Back of
Flange Trim
Cover
31-49141 Rev. 2