Quick Specs Retrofit

MONOGRAM 42" BUILT-IN COLUMNS RETROFIT
Product Specification Revised 10/18
FRONT VIEW
SIDE VIEW
W
24" (61.0)
2"
(5.1)
4 3/4"
(12.1)
7/16" (1.1)
Trim overlap
3 1/2"
(8.9)
E
WATER
41 1/2" (105.4)
18" (45.7)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16"
3 1/2"
(8.9)
75"
(190.5)
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
ZISP420DXSS
SIDE VIEW INSTALLED
UNDER SOFFIT
SOFFIT
SIDE VIEW INSTALLED
WITH WOODEN WALL STUDS
AND NO SOFFIT
FRONT VIEW INSTALLED
WITH METAL WALL STUDS
AND NO SOFFIT
*84"
(213.4)
*Or installation
height from floor
2" x 4"
Cut to 35" Length
Screws mounted
into vertical wall
studs
Top Case Trim
3/4"
Min.
Side View Top
Case Trim
Install Screws
Through Trim and Into
3/4" Min. Wood Brace
The refrigerator will project forward, slightly beyond adjacent cabinetry.
NOTES
STANDARD INSTALLATION
SIDE VIEW
24"
(60.9)
COLUMNS RETROFIT
3 1/2"
(8.9)
Finished
Return
Back
3/4"
(1.91)
W
SIDE VIEW
24" (60.9)
COLUMNS RETROFIT
3 1/2"
(8.9)
Finished
Return
Back
3/4"
(1.91)
W
In a side-by-side installation
of a left-and-right-hand door
swing product, minimum 1/2"
clearance between the units
is required. Also required is
Side-by-Side Heater/Dual
Installation Kit, ZUGC
WARNING:
When installing appliance,
you must use and follow
the product installation
instructions. These can be
found with unit or on web at
monogram.com.
This document is intended
for cabinet and panel
construction only.
A minimum 3 1/2" (8.9)
finished return matching
cabinet exterior
recommended on interior on
all sides and top at front of
opening.
ATTENTION ELECTRICIAN:
A 115 volt 60Hz., 15 or 20 amp
supply is recommended for
each product. An individual
properly grounded branch
circuit or circuit breaker
is recommended. Install a
properly grounded 3-prong
electrical receptacle recessed
into the back wall. Electrical
must be located on rear wall
as shown.
For retro fit installations,
both units can be plugged
into the same electrical
supply receptacle.