Spec Sheet

For questions about your
appliance, please call 1-800-626-2000.
Product Specication Created 10/19PAGE 14 OF 17
e 1/2" overlay panel must be secured
to a .10" spacer panel and a 1/4" thick
backer panel, which slides into the trim.
Assemble the panels with glue
and screws:
• Center the spacer panel on the backer
panel, left to right and top to bottom.
Secure the panels with glue.
• Refer to the chart for locating the
backer panel to the overlay panel.
Secure the overlay panel to the
backer panel with glue and screws.
Screws must be countersunk into
the backer panel
Order a ZKBFN720NII unification
kit for an integrated appearance on
2 custom panel models installed
side-by-side.
Note: For panels constructed with rails
and stiles (5-panel), the rails must be a
minimum of 3" wide and stiles must
be a minimum of 4" wide.
FLUSH INSET
INSTALLATION
HELPFUL TIPS
Grille Panel
Door
Panel
A
B
C
PANEL DIMENSIONS
FLUSH INSET 1/2" PANEL DIMENSIONS SINGLE INSTALLATION
A B C
1/4" Backer Panel 33 7/8" 8 7/8" 69 5/16"
.10" Spacer Panel 32 1/2" 7 5/8" 67 15/16"
1/2" Overlay Panel 38" 10 7/16" 69 3/4"
C
D
A
B
Hinge Side
Backer with
Overlay Panel
Assembly
Door Panel Back
PANEL DIMENSIONS
1/2" OUTER PANEL TO BACKER PLACEMENT
C
D
A B
Grille Back
1/2"
Overlay
Panel
1/4"
Backer
Panel
Door
.10"
Spacer
A B C D
Door Panel 2 1/16" 2 1/16" 3/16" 1/4"
.Grill Panel 2 1/16" 2 1/16" 1 7/16" 1/8"