Specification Sheet

For questions about your
appliance, please call 1-800-626-2000.
PAGE 12 OF 17 Product Specication Revised 10/20
Trimmed refrigerators are designed
to be customized with decorative
panels. Field-installed 1/2" or 3/4"
custom door and grille panels are
required. For 3/4" raised panels,
routing is required. e router depth
is 1/4" all the way around the panel’s
backs. Additional panel width
reductions are required per the
diagrams shown. is will create
“picture frame” routing allowing the
panels to slide into the attached door
and grille trims.
Maximum total panel weight:
• Door panel – 67 lbs.
• Grille panel – 11 lbs
Note: For panels constructed with rails
and stiles (5-panel), the rails must be a
minimum of 3" wide and stiles must be
a minimum of 4" wide.
Door Handles:
Custom handles are required for flush
installation.
Order a ZKBFN720NII unification
kit for an integrated appearance on
2 custom panel models installed
side-by-side.
TOP
FrontBack
BOTTOM
3/4" PANEL SIDE VIEW
(AFTER ROUTING)
3/4"
11/32"
1/4"
1/4"
1/4"
7/16"
DETAIL TOP
DETAIL BOTTOM
DETAIL
LEFT SIDE
DETAIL RIGHT
SIDE
2-1/16"
2-1/16"
ROUTER DEPTH 1/4" ROUTER DEPTH 1/4"
1/4"
3/32"
3/4" PANEL BOTTOM VIEW
(AFTER ROUTING)
LEFT
SIDE
RIGHT
SIDE
Front
Back
Front
NOTE: Routed areas should
be finished as they may be
visible when assembled.
CORNER VIEW SHOWING
“PICTURE FRAME” ROUTING
Back
FLUSH INSET
INSTALLATION
HELPFUL TIPS
3/4" RAISED DOOR PANEL ROUTING