Owner's Manual

Installation Instructions - Stainless Steel Installation
45
HARDWARE SUPPLIED
Water filter bypass plug
Anti-Tip brackets
3 lag screws
2 Hair Pin Cotters
• 4 washers
• 5 toggles with bolts
Toekick
TOOLS AND MATERIALS REQUIRED
Tin snips to cut banding
#2 Phillips screwdriver
Stepladder
Drill and 1/2”, 3/16” bits
Bucket
1/4”, 1/2”, 5/16”, 7/16” socket
Level
Safety glasses
Appliance hand truck
Pliers
Tubing cutter
Stud finder
7/16” and 1-1/4” open-end wrench
1/4” copper water line tubing or SmartConnect
Refrigerator Tubing kits
Water shut-off valve (optional but recommended)
Screws to secure unit to cabinetry
Stick-on hook and loop fastener strips for 1/4”
(0.63 cm) side panels
FLOORING
For proper installation, this product must be placed on a
level surface of hard material that is at the same height
as the rest of the flooring. This surface should be strong
enough to support a fully loaded refrigerator or freezer,
or approximately 1,200 lbs. per unit.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under the
product where you are working.
NOTE: Not recommended for installation on carpeted
flooring.
GROUNDING THE UNIT
WARNING
Electrical Shock Hazard.
Failure to follow these instructions can result in death,
fire, or electrical shock.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
LA TERRE DE L’UNITÉ
AVERTISSEMENT
Risque de choc électrique.
Le non-respect de ces instructions peut entraîner des risques
d’incendies, des chocs électriques ou la mort.
Le cordon d’alimentation de cet appareil est équipé d’une
fiche à trois broches (pour une mise à la terre) qui s’adapte à
la prise de courant standard à 3 broches (pour une mise à la
terre) pour minimiser les risques de chocs électriques par cet
appareil.
Faites vérifier la prise murale et le circuit électrique par un
électricien qualifié pour s’assurer que le système est correcte-
ment mis à la terre.
Dans le cas d’une prise biphasée, l’installateur a la respon-
sabilité et l’obligation de la remplacer par une prise triphasée
correctement mise à la terre.
NE COUPEZ PAS OU N’ENLEVEZ PAS,
SOUS AUCUN PRÉTEXTE, LA TROISIÈME
BROCHE DE MISE À LA TERRE DU
CORDON D’ALIMENTATION.
N’UTILISEZ PAS D’ADAPTATEUR POUR
BRANCHER LE RÉFRIGÉRATEUR À UNE
PRISE BIPHASÉE.
N’UTILISEZ PAS DE RALLONGE AVEC CET APPAREIL.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT OR REMOVE
THE THIRD (GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO
CONNECT THE REFRIGERATOR TO A
2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
GROUNDING THE UNIT (Cont.)
CONEXIÓN A TIERRA DE LA UNIDAD
ADVERTENCIA
Riesgo de Descarga Eléctrica
Si no se siguen estas instrucciones, se podrá producir la
muerte, incendios o descargas eléctricas.
El cable de corriente de este electrodoméstico cuenta con un
enchufe de 3 cables (conexión a tierra) que se conecta a un
tomacorriente de pared estándar de 3 cables (conexión a tie-
rra) para minimizar el riesgo de posibles descargas eléctricas
por parte del mismo.
Contrate a un electricista calificado para que controle el
tomacorriente y el circuito eléctrico, a fin de asegurar que el
enchufe esté correctamente conectado a tierra.
En caso de contar con un tomacorriente de pared de 2 cables,
es su responsabilidad y obligación reemplazarlo por un tomaco-
rriente de pared de 3 cables correctamente conectado a tierra.
NUNCA, BAJO NINGUNA CIRCUNSTANCIA, CORTE NI
ELIMINE EL TERCER CABLE (TIERRA) DEL
CABLE DE CORRIENTE.
NO USE UN ENCHUFE ADAPTADOR PARA
CONECTAR EL REFRIGERADOR A UN
TOMACORRIENTE DE 2 PATAS.
NO USE UN PROLONGADOR CON ESTE
ELECTRODOMÉSTICO.