Quick Specs

For questions about your
appliance, please call 1-800-626-2000.
Product Specication Created 10/19PAGE 13 OF 14
FLUSH INSET INSTALLATION
HELPFUL TIPS
DISPENSER TRIM
RAISED PANEL DESIGN ON DISPENSER MODELS
14"
11 3/4"
DISPENSER TRIM
Freezer Door
3/4" Flush Panel
Ice/Water Dispenser
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
1/2" Overlay Panel
Ice/Water Dispenser
.85"
Total
Thickness
3/4" OVERLAY PANEL DISPENS-
ER TRIM
1/2" OVERLAY PANEL DIS-
PENSER TRIM
A
SIDE VIEW CROSS SECTION
(SHOWING RAISED PANEL WITH
MIDDLE RAIL)
ese refrigerators are supplied
with a dispenser trim for flush
inset panels.
A
PANEL DISPENSER TRIM:
e provided dispenser trim
is designed to fit a total panel
thickness of 3/4" or 0.85".
If the panel is less than 3/4" thick,
a noticeable gap may be created
around the dispenser trim.
If the panel is more than 0.85"
thick, the dispenser trim cannot
be secured to the door.
e overlay panel must be
constructed according to the
specifications shown to achieve
the correct total thickness.
When a raised panel design is
to be used, a custom middle rail
is required.
RAISED PANEL DESIGN ON
DISPENSER MODELS:
When a raised panel design is to be
used, a custom wide middle rail is
required to accept the dispenser trim.
B
e middle rail must be wide
enough to allow for the dispenser
trim to overlap the opening.
C
e middle rail must be 3/4" total
thickness for 3/4" panels or 0.85"
total thickness for 1/2" panels to
accept the dispenser trim.
3/4" or 1/2" Flush Panel
3/4" or .85"
Total
Thickness
C
B