Installation

STEP 11 INSTALL OVERLAY PANELS

Install door panels:

• Open door to 90°. Remove the 6 Phillips head screws

from the door handle.

• Remove the handle. Retain all screws.

• Remove the 6 screws holding the trim, then lift off the

trim. Retain the screws.

• Slide the overlay panel into the door trim.

• Custom handles must be used with flush inset.

Make sure handles are attached before installing

panels.

Dispenser Models Only:

• The dispenser controls protrude beyond the face of

the freezer door. To avoid damage to the dispenser,

the trim at the top of the door should be removed.

• Remove the screws holding the top trim in place.

• Place the assembled freezer panel into the bottom

channel and slide into the hinge side trim.

• Reinstall the top trim piece with the screws.

• There are two sets of holes in the door trim. Replace

door trim by installing all of the screws in the two sets

of screw holes.

• Follow the same procedures to install the opposite

panel.

• Discard the visor handle.

Installation Instructions - Flush Installation