Instructions / Assembly

Installation Instructions - Flush Installation
STEP 10 INSTALL GRILLE PANEL
To insert the framed or overlay panel into the grille:
• Raise the grille panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
Adjust Nut Below
Spring to Accommodate
Panel Weight
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
CAUTION
SHARP EDGE HAZARD
The metal panel may be slippery. Grip the metal panel
firmly so the panel does not slip out of the frame and
cause personal injury or damage to the frame.
ATTENTION
RISQUE DE COUPURE :
ATTENTION AUX ARÊTES VIVES
Le panneau en métal peut bêtre glissant. Tenir
fermement le panneau en métal, de manière à ce
que le panneau ne glisse pas en dehors du cadre
en provoquant des blessures corporelles ou des
dommages au cadre.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
36
31-1000002-1