Owner's Manual

DIMENSIONS AND CLEARANCES
Product Clearances
These refrigerators are equipped with a 3-position door
stop. The factory-set 115° door swing can be adjusted
to 90° if clearance to adjacent cabinets or walls is
restricted. Only standard installation can be adjusted to
130°.
Allow minimum clearances for the freezer door
(Dimension A) and fresh food door (Dimension B) for a
full 115° door swing and to allow for pan removal.
For a 90° door swing, allow 4” (10.16 cm) min.
clearance to a wall, for framed and stainless steel
models. Allow 5” (12.7 cm) min. clearance for
professional series models. If the 90° door stop position
is used, pan access is maintained, but pan removal is
restricted.
THE INSTALLATION SPACE
*Finished cutout width must be:
39” (99.06 cm) for 36” models
45” (114.3 cm) for 42” models
51” (129.54 cm) for 48” models
Water And Electrical Locations
The opening must be prepared with the electrical and
the cold water supply located as shown.
The Cutout Depth Must Be 26-3/16” (66.99 cm)
Wooden cleats are required for flush installation. See
Side Cleats on page 27. If 3/4” (1.91 cm) Overlay
panels w/ 90 degree door swing are to be used then
cutout depth must be 26-1/4” (66.68 cm)
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on the rear wall as shown.
• The water line can enter the opening through the
floor or back wall. The water line should be 1/4” O.D.
copper tubing or SmartConnect
™
kit between the cold
water line and water connection location, long enough
to extend to the front of the refrigerator. Installation of
an easily accessible shut-off valve in the water line is
required.
Design Guide - Flush Inset Installation
26
*Finished Width
6"
5"
Electrical
Area
85" max
Finished
Opening
75" From Floor
to Bottom
of Electrical
Area
26-3/16"
7"
7"
3 1/2"
Water Supply
3 1/2"
36" Models 12"
42" Models 19"
48" Models 22-1/4"
* Shipping height.
The refrigerator can
be adjusted to fit
into a cutout that is
85” (215.9 cm) in
height. Use leveling
legs and wheels
for a maximum 1”
(2.54 cm) height
adjustment.
*84"
From
Floor
25-3/8" Framed Models
Depth Including Handles 26-7/8”
36", 42" or 48"
Frame to Frame
35", 41", or 47"
Case Width
*83-1/2"
at
Rear
90° Door Swing
115° Door Swing
23-7/8"
Behind
Frame
C
*Min. Distance
to Wall
*4” Stainless and
Trimmed Models.
5” Pro Series
B
A
Models A B C
36” 13”
(33.02 cm) 15” (38.1 cm) 20-5/8” (52.39 cm)
42” 13” (33.02 cm) 19” (48.26 cm) 26-5/8” (67.63 cm)
48” 15” (38.1 cm) 20” (50.8 cm) 28-5/8” (72.71 cm)
31-49171 Rev. 2