User Manual

10
Dispenser
with
glass-touch
controls
How it Works
The electronic controls on the dispenser are
truly interactive. The control panel is equipped
with a proximity sensor that causes the panel
to light up as you approach the dispenser
(approx. 2 inches). To make a selection,
simply touch the graphic for the feature you
want, and the halo for that feature will light up.
When you walk away from the refrigerator, the
lighted graphics switch off automatically.
Spill Shelf
Ice & Water Dispenser (on some models)
Built-In Refrigerators
How to Use
To dispense water or ice: select WATER ,
CUBED ICE or CRUSHED ICE . Then
press the glass gently against the top of the
dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf and its grille should
be cleaned regularly.
If no water is dispensed when the refrigerator
is first installed, there may be air in the water
line system. Press the dispenser cradle for at
least two minutes to remove trapped air from
the water line and to fill the water system. To
flush out impurities in the water line, throw
away the first gallon of water.
CAUTION
Never put fingers or
any other objects into the ice crusher
discharge opening.
ATTENTION
Ne mettez jamais les
doigts ou d’autres objets dans l’ouverture
du distributeur.
Locking the Dispenser:
Touch CONTROL LOCK for
3 seconds to lock the dispenser
and control pad. To unlock,
touch it again for 3 seconds.
Dispenser Light:
This feature turns the light on
and off. The light also comes
on when the dispenser cradle is
pressed. If this light burns out,
contact factory service.
Door Alarm:
To turn the Door Alarm feature on,
touch DOOR ALARM once. To
turn it off, press it again.
When the DOOR ALARM is
active, the alarm will flash and
beep if you keep the door open
for more than 2 minutes.