Installation Instructions Side by Side Refrigerators ZlS360N,ZlSB360D,ZlSW360D ZlSS360N,ZlSS360D ZlS420N,ZlSB420D,ZlSW420D ZlSS420N,ZlSS420D ZIS480N,ZISB480D,ZISW480D ZISS480N,ZISS480D Design 6uide With Installation Instructions Monogram:
Safety Information BEFORE YOU BEGIN Read these instructions completely • IMPORTANTfin" local inspector's and ordinances. • Note • Note with with Observe - Be sure the to • These instructions reference. refl-igerators be secured fin'ward. page Anti-Tip • Use This • hmnediately "(;rounding must the be properly Refrigerator," grounded. page See that 10.
Design Guide THE INSTALLATION SPACE DIMENSIONS AND CLEARANCES 25-3/8" FramedModels 25-3/4" StainlessSteelModels 36" Models12" 42" Models18" 48" Models20" _ _Finished 84 1/2" max, , ^ Width_ J J L'" 831/2,, min II AreaElectdc X15 l Finished ][ Opening ] [ 75"FromFloor 24" *The I) finished 35-1/2" 41-1/2" 47-1/2" Water _83-1/ at Real ff Electrical Area to Bottom [_5 / .
Design Guide FramelessCabinets:The case trim overlaps cabinets atthe top and sides. Therefore, frameless cabinets may require filler strips to prevent interfeence with cabinet door swing. The opening must allow for filler strips. Refrigerator 23-7/8"From Rearof Refrigerator .
Design Guide FramelessCabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing. The opening must allow for filler strips.
Design Guide CUSTOMIZATION Framed BASICS: Or Overlay Panels, Custom Handles Stainless Steel Wrapped Models 36" wide models - ZISS360N, ZISS360D 42" wide models - ZISS420N, ZISS420D 48" wide models - ZISS480N, ZISS480D Trimmed - ZIS360N, - ZIS420N, - ZIS480N, ZISB360D, ZISB420D, ZISB480D, ZISW360D ZISW420D ZISW480D r These models // i Stainless Steel Wrapped Refrigerators Stainless Steel wrapped refrigerators have wrapped doors and grille panel, beveled edges, and tubular stainless steel handl
Design Guide 1/4" FRAMED PANEL DIMENSIONS 1_5/18" L If _ou choose cut to the into the to install dimensions fraine on Non-Dispenser If the fl'amed panels, shown. the The door and they panels must Door be Trim Reveal will slide grille.
Design Guide 3/4" OVERLAY PANEL DIMENSIONS OverlayPanel Door For a more custom appearance, overlay panels may be installed on trimmed models. The overlay panel i/ltlst be secured to a 1/4" thick backer panel which slides into the trim. A spacer panel 0.] 0" thick must be placed between the overlay and backer panel. Assemble the panels with glue and screws. • Center the spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.
Design Guide DISPENSER MODELS: RAISED OVERLAY PANEL DESIGN 1/4" Backer When a raised custom the wide panel middle dispenser • The rail is to be is required used, .10" SF a 3/4" OverlayPanel to accept trim. middle rail for the dispenser • The middle rail to accept design the must be wide trim must to overlap be 1.100" dispenser enough to allow the total opening. thickness trim. J Dispenser Trim Wide Middle Railis Required 16-3/4" 10-5/8%___,.
Design Guide SIDE PANELS FLOORING Side panels must be used whenever the sides of the For placed on refrigerator will be exposed. The 1/4" side panels will slip into the side case trim.
Installation Instructions • Remoxe ISTEP 11REMOVE PACKAGING CAUTI0N: Relrigerator is much hea, ier at the PRUDENCE:i,e • Careflflly cut banding reulove otffer carton. ATTEMPT TO ROI,I, UNIT OFF SKID. be...,.p Remove PRUDENCE:n,NE lots TieDowns FAUT PAS ESSAYER DE • Support blocks on the bottom of the refl'igeration case must be removed befi)re the refl'igerator is taken off the skid or damage will occm'. Careflflly; tilt refl'igerator and slide blocks out from beneath.
Installation Instructions ISTEP 2AI INSTALLATION WITH HOUSEHOLD WATER FILTRATION SYSTEM I STEP 41 INSTALL ANTI-TIP BRACKETS WARNING:Am,-T,p PRECAUT,ONS The Skip this step if you do not have a household water filtration system If the water household should be supply water filtration removed. For periin'mance, bypass to the remove refrigerator is fl'om filter and install the the is top-hea_y possibility and must of tipping be secured to forward.
Installation Instructions ISTEP 51 LEVEL REFRIGERATOR I STEP 61 ALTERNATE ANTI-TIP PROCEDURE All models have 4-point leveling. The thmt is supported by leveling a_!justable wheels. of the legs, Both the are rear is supported by fl'om the fl'ont turn the accessible The 7/16" the back hex clockwise nut of the located to raise refligerator, above or the fl'ont wheels.
Installation Instructions ISTEP71SECURE REFRIGERATOR [STEP 9] INSTALL GRILLE PANEL TO CABINETRY _'_ henexer security The i)erfiwm or when anti-tip refrigerator • Raise the • Drill into possible, hole grille panel in trim ac!jacent • Follow must the and be this step brackets cannot secured to prevent to access drive case screw To insert fl'amed • Raise the grille for anti-tip be or o_erla) panel into the grille: panel to stop position. used, tipping. trim.
Installation ISTEP 101 INSTALL Instructions 1/4" FRAMED PANELS Go to Step9Afor OverlayPanels Handle j DoorTrim Trim Refrigerator Door Supplied Handle Shown in I/4" Panel Position -Install door panels: • Open door to 90 °. l_.elnove the 6 Phillips fl'om the door handle. • Relnove handle. Retain all screws. • Remove screws. 6 screws • Slide fl'amed panel holding into trim, head lilt otI trim. the door screws Retain trim.
Installation Instructions [STEP 10A] INSTALL OVERLAY PANELS DoorTrim Handle Trim Refrigerator Door Move Forward For3/4" Panel Supplied Handle Shown in Overlay Panel Position Install • door Open panels: door to 90 °. Relnove tile door handle. fl'om tile all • Remove handle. Retain • Remove 6 screws holding 6 Phillips head screws screws. trim, lift off trim. Retain scFews.
Installation Instructions ISTEP IOA] (continued) Custom ISTEP IOA] (continued) Handles • Carefully place the aluminum cover trim into top end cap so that the recess is aligned with the cap. Use the top to bottom grooves ahmg the handle side to align the cover trim accurately: Pull tape a tew inches at a time while pressing the trim against the door. Press and hold approximately 10 seconds befl)re continuing ahmg the length of the door.
Installation Instructions [STEP 111 INSTALL DISPENSER TRIM [STEP 12] CONNECT WATER SUPPLY 1[ Skip this step is you are installing a stainless steel wrapped or a non-dispenser refrigerator. There are two refrigerator, dispenser Select trims the shii_ped ai)i)ropriate with tFim E )our fin" _our application, Framed Panel Trim Overlay Panel Trim > WaterSupply_ • i,ocate and bring tubing to the fl'ont of the cabinet. • Turn the water on to flush debris fl'om line.
Installation Instructions ISTEP 15] INSTALL TOEKICK ISTEP 131 CHECK POWER, CLOSE GRILLE PANEL • Check the to be sure the power cord is I)lugged,, • I,ocate the into the side provided, receptacle, suI)plied of the toekick (shii)ped refrigerator). a(!just taped Install to desired with height and to 2 screws tighten scFews.
NOTE:While performing installations described in this book, safety glasses or goggles should be worn. o 6) /_r 3/_0)zog'r.m Iocnl s(o-vice i)z ._(mr (m_., c(dl l.(500.444, l,_4). NOTE:})ro(|ti(:l (;(:n(:r_d sl)(_tifl(:aliolls Pub.No. 49-60314 h_ll)l-()'_(m( El(_(tri(:. Th(:r(:fLr¢_, m'(_ sulzje(t ill i'_ a (:olHilitlillg mal(_rials, to (ll_lllg( (_n(l(avor _/i)l)(ai-an( W]lhotll _lt ¢ a11(1 lloli(:(. Monogram: Dwg.No.
