Owner`s manual

Installation Instructions
STEP 10] INSTALL DISPENSER
TRIM
Skip this step is you are installing a stainless
steel wrapped or a non-dispenser refrigerator.
There are two dispenser trims shipped with your
refligeratoL Select the appropriate trim for your
applicad on.
Overlay
I Panel
I mm
Comparethe dispenser trims. Note that the inside
depth of the frames are different, Choosethe trim
with less depth for framed panels, choose the
deeper one for overlay panels.
Dispenser trim fit over the custom panel depends on
correct panel thickness. See pages 7 and 8 for panel
construction information.
• Press and snap the dispenser trim into the dis-
penser recess on the refrigerator dooL
If an excessive gap exists around the dispenser trim
or if the panel fits loosely in the door flame, foam
tape may be applied to help improve the fit. Remove
the trim and panel and apply foam tape to the door
around the dispenser and in the corners.
STEP 11 CONNECT WATER SUPPLY
Check to be sure that refrigerator power cord is not
plugged into the wall outlet.
11
I
---.
,\ Refrigerator House
"-\.Water Supply Water Supply//
• I,ocate and bring tubing to the flont of the cabinet.
• Turn the water on to flush debris from line. Run
about a quart of water through robing into a bucket,
then shut-off wateL
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both
ends of the copper tubing. Insert robe into the
union fitting on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect TM Tubing:
• Insert the molded end of the robing into the
refligerator connection. Tighten the compression
ntlt until it isjust hand tight.
• Tighten one additional turn with a wrench.
Overdghtening can cause leaks!
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with toekick installation.
17