Specifications

Installation Instructions
STEP 1 REMOVE PACKAGING
CAUTION: The refrigerator is much heavier at
the top than at the bottom—be careful when moving.
When using a hand truck, handle from the side only.
PRUDENCE: Le réfrigérateur est beaucoup
plus lourd en haut qu’en bas. Il faut être prudent lors
des déplacements. Si un diable est utilisé, il faut soulever
le réfrigérateur sur le côté seulement.
• Carefully cut banding at the top and bottom,
remove the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE: IT IS NOT NECESSARY TO LAY THE CABINET DOWN
IN ORDER TO REMOVE THE SKID!
• The unit is secured to the skid with 4 slotted
tie-down straps. Remove the six 7/16" bolts
from the base channels in the tie-downs.
• Remove the six 7/16"
bolts securing the straps
to the skid.
CAUTION: DO NOT
ATTEMPT TO ROLL UNIT
OFF SKID.
PRUDENCE: IL NE
FAUT PAS ESSAYER DE FAIRE
ROULER LE RÉFRIGÉRATEUR
POUR L’ENLEVER DE LAY
PALETTE.
STEP 3 INSTALL WATER LINE
• A cold water supply is required for automatic
icemaker operation. The water pressure must
be between 40 and 120 p.s.i.
• Route 1/4" OD copper or GE SmartConnect
™
plastic tubing between house cold water line
and the water connection location.
• The tubing should be long enough to extend
to the front of the refrigerator. Allow enough tubing
to accommodate the bend leading into the water line
connection.
11
Remove
Tie Downs
Toekick
• The support blocks on the bottom of the refrigeration
case must be removed before the refrigerator is
taken off the skid or damage will occur. Carefully
tilt the refrigerator and slide the blocks out from
beneath.
• Remove the toekick and set aside for final installation.
• Lift the refrigerator off the skid with an appliance
dolly. Handle from the sides.
Floor
Cold Water Line
NOTE: The only GE approved plastic tubing is supplied
in the GE SmartConnect
™
Refrigerator Tubing kits.
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types
of plastic may crack or rupture with age and cause
water damage to your home.
GE SmartConnect
™
Refrigerator Tubing Kits are
available in the following lengths:
2' (.6 m) WX08X10002
6' (1.8 m) WX08X10006
15' (4.6 m) WX08X10015
25' (7.6 m) WX08X10025
STEP 2 MOVE THE REFRIGERATOR INTO THE HOUSE
• Re-use the corner posts from the packaging to protect stainless steel models. Run the appliance dolly straps over
the posts and under the handles.
• Leave the protective film on the refrigerator until installation is complete.
IMPORTANT: Never lift the refrigerator by the handle or push against the grill panel; this could cause damage
or misalignment.
• Avoid laying the unit on its back or side to prevent sealed system restrictions.
www.dexpress.com Page 42 of 42 12/1/2010
www.dexpress.com Page 42 of 42 12/1/2010
ZISP420DXSS
ZISP420DXSS
Cond Inst
Cond Inst