Installation Instructions

41
THE INSTALLATION SPACE
Water And Electrical Locations
Electrical and water supply must be located as shown.
Cutout Depth Beneath a Soffit:
When installed beneath a soffit, the soffit cannot
exceed the 26-3/16” (66.52 cm) installation depth
shown.
The Cutout Depth Must Be 26-3/16” (66.52 cm)
Wooden cleats are required for flush installation. See
Side Cleats on page 48.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter the opening through the floor or
back wall. The water line should be 1/4” O.D. copper
tubing or QuickConnect
™
kit between the cold water
line and water connection location, long enough
to extend to the front of the unit. Installation of an
easily accessible shut-off valve in the water line is
required.
DIMENSIONS AND CLEARANCES
Product Clearances
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted
to 90° if clearance to adjacent cabinets or walls is
restricted.
For a 90° door swing, allow 4-5/8” (10.16 cm)
minimum clearance to a wall for framed and stainless
steel models. If the 90° doorstop position is used, pan
access is maintained but pan removal is restricted.
39”
Finished Width
Wall View
Electrical
Area
26-3/16” Minimum
Cutout Depth
Cold Water
Supply
75-1/2” From
Floor to Bottom
of Electrical Area
85”
Finished
Opening
4-5/16”
3-1/2” 3-1/2”
3-1/2”
3-1/2” 3-1/2”
5-1/2”
9”
7” 7”
90° Door Swing
90° Door Swing
4” Minimum
to a Wall
90°
23-7/8”
Case Behind
Frame
38-3/4”
115° Door Swing
15"
Min. to
Wall
115°
38-3/4" Frame to
Frame Width
*84" From
Floor to
Top Frame
35"
Case Width
*83-1/2"
at
Rear
Depth Including
3/4" Panels 25-15/16"
* Shipping height. The
product can be adjusted
to fit into a cutout that
is 85” (215.9 cm) max.
height. Use leveling
legs and wheels for a
maximum 1” (2.54 cm)
height adjustment.
Design Guide - Flush Inset Installation for
All-Refrigerator and All-Freezer
31-1000454 Rev. 0