Installation Instructions

48
Design Guide - Flush Inset Installation for
All-Refrigerator and All-Freezer
5-1/4”
Finished
Cleat
Case Trim
1/2”
3/4” Panel
DOOR
TOP VIEW
5-3/8”
Finished
Cleat
Case Trim
1/2”
1/2” Panel
DOOR
TOP VIEW
SIDE PANELS
Side panels must be
used whenever the
sides of the unit will be
exposed. The 1/4” (0.63
cm) side panels will slip
into the side case trim.
Secure the panels to
the unit with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on
installation height.
ZKBFN720NII Unification Kit
The ZKBFN720NII Unification Kit provides for the
installation of a framed or overlay grille panel.
NOTE: For 3/4” (1.91 cm) panels , use the same routing
instructions as single installation, page 45.
IMPORTANT NOTE: The maximum weight for the
unified grill is 25 (11.34 kg) pounds.
Assemble the overlay panels in the same manner
as the door panel.
UNIFIED DOOR PANEL DIMENSIONS
Door panel dimensions for dual installation will be
69-3/4” ( 177.16 cm) x 36-7/8” (93.66 cm). For 3/4”
(1.90 cm) panels follow the same routing procedure per
instructions on page 46.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
SIDE CLEATS
Wood cleats are required to be installed vertically down
both sides of the cabinet opening to provide depth stop
for the refrigerator when installed into the opening.
The cleat should be installed per the diagrams below
based on the type of panel being used.
*84"
2-9/16"
24"
*3" to 4"
3/16"
1-7/8"
Framed Panel Dimensions
3/4” (1.91 cm)
Routed Panel
A (Width) B (Height)
74” (187.96 cm) 10-7/16” (26.51 cm)
Overlay Panel Dimensions
1/4” (0.63 cm)
Backer Panel
A (Width) B (Height)
69-7/8” (177.48 cm) 8-7/8” (22.54 cm)
0.10” (0.25 cm)
Spacer Panel
68-1/2” (173.99 cm) 7-5/8” (19.37 cm)
1/2” (1.27 cm)
Smooth Panel
74” (187396 cm) 10-7/16” (26.51 cm)
31-1000454 Rev. 0