Installation Instructions

9
Design Guide - Flush Inset Installation for French Door
Bottom Freezer Refrigerator
3/4” (1.9 cm) DECORATIVE PANEL
DIMENSIONS
For a more custom
appearance, overlay panels
may be installed to give
a flush appearance with
surrounding cabinets. The
overlay panel must be
3/4” (1.9 cm) thick. Panel
attaches to included brackets
to provide mounting to the
appliance door.
NOTE: We recommend that
decorative panels have inside
corners and edges rounded
or beveled by cabinet maker
to avoid sharp edges on the
panels. Edges to be treated
should include the top, bottom and hinge side edges.
IMPORTANT NOTE: Maximum total weight for the
assembled panels:
• Fresh food door panels – 30 lbs. (14 kg)
• Freezer drawer panel – 28 lbs.(13 kg)
• Grille Panel – 11 lbs. (5 kg)
WARNING
d
Door Trim Pinch Point Hazard
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children. To
minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
AVERTISSEMENT
d
Risque de pincement
de doigts
Une installation incorrecte peut poser un risque de coincement
de doigts entre la garniture de porte latérale et les armoires
en actionnant la porte, en particulier pour les enfants.
Pour réduire ce risque, vous devez suivre les instructions
d’installation relatives aux dimensions d’armoire, au montage
des garnitures et à l’angle de l’arrêt de porte.
ADVERTENCIA
d
Riesgo de Lastimadura
con el Marco de la Puerta
Una instalación inadecuada podrá conducir a riesgos de
pellizcos de dedos entre el marco lateral de la puerta y los
gabinetes al utilizar la puerta, especialmente con los niños.
A fin de minimizar este riesgo, usted deberá seguir las
instrucciones de instalación para dimensiones de gabinetes,
ensambles de marcos y ángulos de detención de puertas.
Grille Panel
Fresh
Food
Panel
Fresh
Food
Panel
38"
18-3/4" 18-3/4"
10-13/16"
Freezer Drawer
Panel
22-3/8"
46-7/16"
CUSTOMIZATION BASICS:
Framed Or Overlay Panels, Custom
Handles and Accessory Kits
These refrigerators are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
31-1000454 Rev. 0