installation instructions

Installation Instructions - Flush Inset Installation for

All-Refrigerator and All-Freezer

STEP 8 ADJUST DOOR SWING

(Cont.)

ADVERTENCIA

Riesgo de Lastimadura

con el Borde de la Puerta

Una instalación inadecuada puede conducir a riesgos de

pellizcos de dedos entre el borde lateral de la puerta y los

gabinetes al utilizar la puerta, especialmente con los niños.

A fin de minimizar este riesgo, usted deberá seguir las

instrucciones de instalación para dimensiones de gabinetes,

ensambles de bordes y esquinas de detención de puertas.

STEP 9 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.

• Loosen the screws on the side trim behind the frame.

Remove the bottom trim.

• Slide the panel over the metal backer panel and into

the trim.

• If necessary, tap with a wood block until the panel

slips under the top trim piece.

• Reassemble the bottom trim. Tighten the screws.

STEP 10 INSTALL OVERLAY

PANELS

Install door panels:

• Open door to 90°.

• Remove the 12 screws holding the trim, then lift off

the trim. Retain the screws.

Custom Handles

• Custom handles must be used for flush

installation. The handle must be properly secured

to the overlay panel before sliding the panel into

the trim.

• The cabinet

manufacturer

will supply the

custom handle and

hardware.

• Slide assembled door

panel into the trim.

• Reinstall trim by

securing with all 12

screws retained in

previous steps.

31-1000454 Rev. 0