installation instructions

Installation Instructions - Flush Inset Installation for

Side-by-Side Refrigerator

STEP 15 INSTALL TOEKICKS

• Flush Installation toekicks are provided in Kit ZKFN.

• Locate the inner and outer toekicks as indicated

below. Recycle all other toekicks.

• Attach the inner toekick to the refrigerator using

ONLY the top center hole (1).

• Attach the outer toekick to the refrigerator using the

three lower slots (2).

• A custom toekick can be installed to match or

complement the surrounding cabinetry. Use the

supplied toekick as a template to cut the shape.

INSPECT FINAL INSTALLATION

Check door alignment. Stand back away from the

refrigerator to inspect the final installation.

• Check to be sure the handles are evenly aligned with

each other at the top. To adjust, loosen the handle

screws and slide up or down. Tighten the screws.

• Shipping or the addition of heavy door panels may

have caused the doors to move slightly out of

alignment.

• If necessary, the fresh food door may be adjusted up

or down to align with the freezer door.

• Use a 5/16” wrench to adjust the hinge pin as shown.

Bushing

Door Hinge

Case Hinge

5/16" Wrench

Raise

Door Out of

Alignment

A (36" Dispense)

B (42" Dispense) or BN (42" Non-Dispense)

C (48" Dispense) or CN (48" Non-Dispense)

AA (36"), BB (42") or CC (45")

31-1000454 Rev. 0