Manual / Installation

Listed by
Underwriters
Laboratories
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
MONOGRAM 30" FULLY INTEGRATED CUSTOMIZABLE
REFRIGERATORS FOR DUAL INSTALLATION
ZIC30GNNII/
ZIK30GNNII
Product Specification Revised 8/19
The Installation Space
The finished cutout width must be 30".
The cutout depth must be 25" for flush installations.
- The front face of the refrigerator fits flush with 25"
depth adjacent cabinets.
Electrical
A 115V, 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
Note: GFI (ground fault interrupter) is not
recommended.
Water Line
- A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 p.s.i.
- Route 1/4" OD copper or GE SmartConnect
™
plastic
tubing between the house cold water line and the
water connection location.
- Tubing should be long enough to extend to the
front of the refrigerator. Allow enough tubing to
accommodate a bend leading into the water line
connection.
- Water line can enter an opening through the floor or
back wall.
- Install a shut-off valve between the icemaker water
valve and cold water supply in the home.
Note: When two units are placed side
by side, order heater kit ZUG30.
60" shed Width
Wall
View
84"
max
80"
min
Finished
Opening
25"min. Cutout
epth
77"
6"
Anti-tip location do not obstruct
Water Tube & Electrical Outlet
Fini
D
3/4"
23-3/4"
29-3/4"
1/8"
1-1/4"
4"
3-1/8"
Height adjustable
from 79-3/8" to 80-3/8" *
4"
Height options
80" or * 84"
25" min. depth
30" Finished Width