Spec Sheet

ManualsBrandsMonogram ManualsCooking Appliances27 Inch Warming Drawer with 1.67 Cu. Ft. Capacity, Variable Degree Control, Variable Humidity Control, Indicator Light, Elevated Half Rack, Proof Mode, and ADA Compliant

PAGE 1 OF 4

For questions about your

appliance, please call 1-800-626-2000.

Product Specication Created 10/19

MONOGRAM 27" STAINLESS STEEL

WARMING DRAWER

ZKW700SSNSS

THE MONOGRAM MINIMALIST COLLECTION

Streamlined design and precisely machined metals create a

contemporary yet functional aesthetic

1.6 CU. FT. CAPACITY

"ON" INDICATOR LIGHT

INFINITE SETTING TEMPERATURE CONTROL

VARIABLE HUMIDITY CONTROL

Crisp to moist

REMOVABLE HALF RACK

STAINLESS STEEL DRAWER FRONT

WITH MINIMAL HANDLE

FULL EXTENSION DRAWER ON BALL

BEARING GLIDES

ON/OFF ROCKER SWITCH

ADA

COMPLIANT

Summary of content (4 pages)

PAGE 1
MONOGRAM 27" STAINLESS STEEL WARMING DRAWER ZKW700SSNSS ADA COMPLIANT THE MONOGRAM MINIMALIST COLLECTION Streamlined design and precisely machined metals create a contemporary yet functional aesthetic 1.6 CU. FT.
PAGE 2
OVERALL DIMENSIONS ZTW700SSNSS 26 3/4" (68.0) 3/8" (.95) 9 1/4" 10 1/2" (23.5) cutout height SPECIFICATIONS Overall Width 26 3/4" (68.0 cm) Overall Height 10 1/2" (26.7 cm) Overall Depth 23 1/4" (59.0 cm) Drawer Capacity 1.67 cu. ft. (47.3 l) Cut-out Width 25 1/2" (64.8 cm) Cut-out Height 9 1/4" (23.5 cm) Cut-out Depth 23 1/2" (59.7 cm) Power Cord Length 56" (142.2 cm) Electrical Rating 450W @ 120V/60Hz Total Amps 15 Amps Net Weight 53 lbs. (23.6 kg) Approx.
PAGE 3
ZTW700SSNSS INSTALLATION BELOW SINGLE OR DOUBLE WALL OVEN HELPFUL TIPS ZTW700SSNSS A Warming drawers are approved for installation below only certain specified wall oven and cooktop models. See the label attached to the top of the warming drawer for approved combinations. TOP VIEW Side cleats B A dditional clearance between cut-outs may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 23-1/2" depth and 9-1/4" height.
PAGE 4
ZTW700SSNSS INSTALLATION BELOW A CABINET DRAWER ZTW700SSNSS HELPFUL TIPS A I f you are installing in frameless cabinets, it may be necessary to install 1/2" wide cleats to accept drawer mounting screws. See drawer for mounting screw locations. ZTW700SSNSS TOP VIEW B I nstall a 2"x2" or 2"x4" anti-tip block against rear wall, 9" from floor of cutout to bottom of block. The anti-tip block must be installed to prevent the drawer from tipping forward when opened and loaded.