Installation

Design Information
4
PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model.
TOOLS AND PARTS REQUIRED
(NOT SUPPLIED)
 #2 Phillips screwdriver

Hand-held drill

High speed drill bit, 3/32s diameter

3/8s slot-head screwdriver

Level

Saw

2 x 4 or 2 x 2 lumber for installing runners or 3/8s
plywood for floor (if required)

Wood screws or other hardware for installing
runner or shelf to support oven (if required)

Safety glasses or goggles
PARTS SUPPLIED
 6 screws (3 required, 3 extra)

5 color-matched screws (4 required, 1 extra)

Bottom trim (2)
ADVANCE PLANNING
 These ovens may be installed directly into a 30s wide
oven cabinet.
 Cutout dimensions are NOT the same for installation
with or without an accessory storage drawer.
Make sure to use the correct cutout when preparing
the opening.
NOTE: ZSC1202 models CANNOT be installed with
an accessory storage drawer. See Installation
Preparation Without an Accessory Storage Drawer
for this model.
$OORZIRUFOHDUDQFHWRDGMDFHQWFRUQHUVZDOOV
drawers, etc.
The oven must be securely installed in a cabinet
that is firmly attached to the house structure.
Weight on the oven door could cause the oven to tip
and result in injury. Never allow anyone to climb, sit,
stand or hang on the oven door.
If installing the drawer accessory, the drawer must
be assembled to the oven prior to installation into
the cabinet. See the Accessory Storage Drawer
Assembly Instructions.
21-1/2s
1s
13s
19s
29-3/4s
1-3/5s
1-1/10s