Owner`s manual

Installation Instructions
ISTEP 2A I INSTALL HOOD ONTO WALL
SKIPTHIS STEPIF INSTALLINGBENEATHA SOFFITOR CABINET,
GO TO STEP2B.
Locateat least2 vertical studsat the wood support.
Centerthe suppliedwood support,left to right and belowthe
20" markedline.
Bottom
of__
Hood
IMPORTANT: Framing must be capable of
supporting up to 150 Ibs.
Install Transition Onto Top of Hood
I
IMPORTANT:Remove
•-,, - .... shipping tape from
damper and check that
damper moves freely.
3 Wood
i! Support
ii
i,
ii
i,
f,
\ Centerlineof [_______I
Installation
Space J
,i
Securethe wood supportto 2 or more vertical studs,using at
least2 of the/4suppliedlong screws.
IMPORTANT:Screwsmustpenetrateat least1-1/2" into vertical
studs.Countersinkscrewsinto support.
Note: The mounting
screws must remain in
their original shipping
location. These screws
are positioned to
engage the keghole
slots in the back of
]
i
i
i
i
i
the hood.
- i
-i
/'
OriginalMounting
ScrewsasShipped
Adjustdepth of originalmounting screwsin the wood support
until theg protrude 1//4"forward. This1//4"gap will provide
clearanceto hangthe hood.
Duct
Transition
Placethe duct transition piece overthe hoodexhaustandsecure
with/4 screwsprovided.
Useduct tape to sealthe connection.Checkto besurethe
damper movesfreely.
Hung Hood OnWood Support
Lift the hood and holdcloseto the installation location.Route
housewiring through the knockoutand into thejunction box.
Placethe hood overthe wood support.Besurethe mounting
screwsengagethe kegholeslotsin the backof the hood.Tighten
the screws.
WARNING: Continueto provideadditional support
while the hoodis mountedwith onlgthese 2screws.Thesescrews
will not supportthe weight of the hood.Thehood couldfall
resultingin damage or personalinjurg.
_V _"I_II_ C m I_I_I|- Continuez(_fournirunsoutien
additionnelpendantlemontagedelahotteaveccesdeuxvisseulement,
Cesdeuxvisnesoutiendrontpaslepoidsdelahotte.Lohottepeuttomber,
occasionnantdesblessurescorporellesoudesdommagesmat@riels.
• Checkto be surethe hoodis leveland centered.
Bottom
Mounting
Holes
30"
to
36"
Test Duct CoverFit
Centerlineof
Installation
Space
Placeduct cover(s)overthe top of the hoodto checkfor gaps.
Adjustthe hood up or down if necessary.
Install Bottom Mounting Screws
Drill 1/8"pilot holesintothe two lower mountingholes.Enlarge
the holesif theg did not enter studsto 3/8".insert anchors
for wall fastenersinto bottom holes.Removeanchor screws
and addflat washersprovided.Drivescrewsinto anchorsand
tighten.
install/4 additional screwsthrough the backofthe hood and
into the wood support.