Owner`s manual

Installation instructions
STEP 3 CONNECT DUCTWORK
. Install ductwork, making connections in direction of
airflow as illustrated.
. Secure joints in ductwork with sheetmetal screws.
. Wrap all duct joints with duct tape for an airtight seal.
, Useduct tape to seal the flange connection. Reach
inside the hood and push the dumper up to be sure it
moves freelg.
Air Flow
Duct Tape
Over
and Screw Screw
Duct Tape//
Over Transition
jSTEP 4 CONNECT
ELECTRICAL
Verify that power is turned off at the source.
AWARNING: If house wiring is not
2-wire with a ground wire, a ground must be provided bg
the installer. When house wiring is aluminum, be sure to
use U.L.approved anti-oxidant compound
and aluminum-to-copper connectors.
A AVERTISSEM ENT Sile cablage de
la maison n'est pas du tgpe a deux ills avec un fil de
terre, I'installateur doit fournir un circuit de terre. Quand
les ills de la maison sont en aluminium, il prendre soin
d'utiliser de la pate antioxidation approuv@ par ULet
des connecteurs pour I'aluminium-cuivre.
A Remove B Insert Power
Junction Box Conduit Thru
Cover Strain Relief
and Tighten
C Use UL Listed
Wire Nuts
* Use wire nuts to connect incoming ground to green,
white to white and black to black.
* Push wires into junction box and replace cover. Be sure
wires are not pinched.
STEP 5 INSTALL DUCT COVERS
Note: For easier handling, remove cardboard insert after
film is peeled off.
Remove protective film from duct covers. If more than
one duct cover is used, secure each piece together with
screws provided.
. Place the duct cover(s) on top of the hood.
. From inside the hood, secure the duct cover to the top
with the small Phillips head screws supplied with the
covers.
[STEP 6 INSTALL MOTOR
Outlet
Attachment
Slot
Spring
Clip
. From the inside of the hood, slip motor into the
attachment slot on the left.
. Rotate motor upwards until it snaps into the spring clip
on the right.
. Secure the motor to the hood with the machine screw
and lock washer. (Screw is marked with red or blue
paint.)
Attachment
Top
Screw
I
I
IMPORTANT:Connector
ends are designed to mate
onlg one wag. Match flat and
round connectors as shown.
7
i
/
/
Spring
Clip
. Plug connector into the motor.
4- 49 80151 8